Pioneer VSX-452 사용 설명서 - 페이지 11
{카테고리_이름} Pioneer VSX-452에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSX-452 24 페이지. Audio/video stereo receiver
페이지 인쇄
* Illustration
shows
U.S.
and Canadian
models.
Q
®
®®@
®
®
I
®
@
®
@
@®@
@
FM/AM
ANTENNA
terminals
(-I_ Page 7)
Connectto FM andAM antennas.
_) PHONO
input jacks (-I_ Page 7)
Connect
to the output
cables from a turntable.
(_) CD input jacks (-I_ Page 7)
Connect
to the output
jacks of a compact
disc player.
_) GND terminal (,,_ Page 7).
Connect
the turntable
ground
lead to this terminal.
Loosen the screw, connect the ground lead, and then tighten the screw.
(_) LD input jacks (-I_ Page 8)
Connect
to an LD player's
output
jacks (audio, video).
(_ REAR SPEAKERS terminals
(-I_ Page 9)
Connect
the rear speakers to these
terminals.
Use rear speakers
of impedance
8 _--
16 Q.
Q CENTER SPEAKER terminals (-I_ Page 9)
Connect
the center speaker
to these terminals.
Use center speakers
of impedance
8 Q--16
t_.
CENTER AMP PRE OUT jack (-I_ Page 7}
When
a separate
power
amplifier
is used to drive the surround
center
speaker,
connect
the power
amplifier
to this jack.
_) TAPE 2 MONITOR jacks (-I_ Page 7)
Connect
to audio
components
such
as a second
cassette
deck
or
graphic
equalizer.
_) VCR/TAPE 1 jacks (-I_ Pages 7, 8)
Connect
to the first cassette
deck or a VCR. With a VCR, also connect
the video jacks.
(_VIDEO
OUT (TO MONITOR
TV) jack (,-_ Page 8)
Connectto a monitorTV.
(_ FRONT SPEAKERS terminals |-I_ Page 9)
A: Connect
to the first set of speakers.
B: Connect
to the second set of speakers.
Use speakers
of impedance
8 Q--16
0.
(_) CONTROL IN/OUT jacks
IN:
Connect
this jack
to other
Pioneer
components
(main unit or
remote
control
unit) when
using those components
to control
this unit.
OUT:
Connect
this jack to other Pioneer components
when using the
remote
control
of this unit to control
the other components.
NOTE:
The receiver's
remote sensor does not function
when a plug is inserted
in IN jack.
To operate, point the remote control
unit at the remote sensor
on the component
to which the receiver's
IN jack
is connected.
When using
the MR-IO0
uni
___._
Receiver
(_
/M
Pioneer component
/'L"L}"
bearing the _'1!mark'
/
I
To the CONTROL IN
Remote
jack of the Pioneer
control unit
component bearing
the _1 mark.
(_ MULTI-ROOM REMOTE IN jack
(-I_ Page 10)
Connect to the separately
sold MR- 100 Multi-Room
remote control unit.
11
<ARB1424>