Pioneer VSX94TXH - Elite AV Receiver 사용 설명서 - 페이지 6
{카테고리_이름} Pioneer VSX94TXH - Elite AV Receiver에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSX94TXH - Elite AV Receiver 8 페이지. Elite a/v receiver firmware update instructions for hdmi, dsp, event, and main microcomputers, dsp1 & dsp2 flash rom
Pioneer VSX94TXH - Elite AV Receiver에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (19 페이지)
페이지 인쇄
MAIN microcomputer:
1. Follow the steps under "I. HDMI, DSP, EVENT, and MAIN microcomputers", "Preparations:" on page 2.
2. Enter Service Mode by holding the "ENTER" (21) and then the "MULTI- ZONE ON/OFF" (15) keys together for about
3 seconds.
3. Within 4 seconds press the
4. Within 4 seconds press the "ENTER" (21) key and "MAIN DL [GO ON]" is displayed.
Open the UFU.exe program and select "Full" in "Mode Select" box. Click on the "File Selection" button.
5.
6. Select the latest MAIN u-com firmware file (Example: 07MID_main_1006(071011).mot). Check Pioneer's ASC
website for the latest firmware files.
7. Select communication port/speed and format:
•
Select the COM Port. This must match the available COM port on your PC. Ex: COM 1
Note: If
"Target device is
for the correct type, cable connections, and COM port settings on your PC.
•
Base speed: 19,200.
•
Data Send speed: 57,600 or 19,200. Try 57,600 first as this will shorten the upgrade time.
•
Transmission format: "S"
8.
Click on the "START" button.
The UFU software will check the communication and baud rate between the PC and AV receiver and then downloading
should start in a few seconds. If the update failed after the "Erasing FLASH memory" the unit may remain stuck
"MAIN DL [GO ON]" mode. Follow the "MAIN microcomputer Firmware Forcible Update Procedure" on pg. 8.
9.
When finished "Update complete" is shown in the "Update Information" box and the receiver will turn off then back on.
This can take up to 12 minutes.
Note: If you want to upgrade another unit with the same firmware. Just click "START" again. Click "EXIT' when you
want to change to different firmware or have finished with all the updates.
10.
Disconnect the receiver's AC for 10 seconds and then reconnect it. Exit the UFU.exe program.
11.
Check the version. See page 7.
(21) key to select "MAIN DL [START]".
connected" is not shown in the "Update Information" box, check the RS232c cable
6
Pioneer Electronics Service, Inc
SE Dept, QA Division
Rev date: 07/02/2008