Pioneer A9 사용 설명서 - 페이지 15

{카테고리_이름} Pioneer A9에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A9 28 페이지. Non swithing amp
Pioneer A9에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 서비스 매뉴얼 (13 페이지), 사용 설명서 (16 페이지), 서비스 매뉴얼 (5 페이지)

페이지 인쇄

Listening to your system

Chapter 4:

Listening to your system

Using Direct listening

Use the Direct listening feature when you want

to hear the truest possible reproduction of a

source. All unnecessary signal processing

bypassed, and you're left with the pure sound

source.

•

While listening to a source, press DIRECT

to switch Direct listening on or off.

Using the Sound Retriever

When audio data is removed during the

compression process, sound quality often

suffers from an uneven sound image. The

analog Sound Retriever feature employs new

technology that helps remove the adverse

effects of compressing 2-channel audio files by

restoring bandwidth and smoothing jagged

artifacts left over after they have been

compressed, resulting in a wider sound stage.

•

Press S. RETRIEVER to switch the sound

retriever on or off.

The

indicator in the front display lights to

indicate the Sound Retriever is on.

Using the balance and tone

controls

Depending on what you are listening to, you

may want to adjust the bass, treble or left/right

balance using the remote control.

Note

1 The Sound Retriever, balance and tone controls are disabled, and the front panel display switches off.

Press TONE/BAL to select the option you

want, then use the L/– and R/+ buttons to

adjust as necessary.

• BASS – Adjust the amount of bass from

–10 to +10.

• TRE – Adjust the amount of treble from

–10 to +10.

• BAL – Adjust the amount of left/right

balance as you like. FLAT indicates a

centered balance.

Wait about five seconds for your changes to be

input automatically. The BASS and TREBLE

indicators light in the front panel when the

corresponding tone control is active.

• To return to the flat setting (tone control

off), press L/– and R/+ at the same time.

Playing other sources

Turn on the power of the playback

component.

Turn on the power of the receiver.

Select the source you want to playback.

Use the input select buttons (or INPUT

SELECTOR dial).

Start playback of the component you

selected in step 1.