Pioneer A9 사용 설명서 - 페이지 9

{카테고리_이름} Pioneer A9에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A9 28 페이지. Non swithing amp
Pioneer A9에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 서비스 매뉴얼 (13 페이지), 사용 설명서 (16 페이지), 서비스 매뉴얼 (5 페이지)

페이지 인쇄

Connecting up

• Connect any other components (such as

an iPod

dock or a portable audio player) to

the AUX inputs in the same way.

Connect the analog outputs of your tape

deck (or other recorder) to the TAPE inputs

(IN) on this receiver. Then connect the audio

inputs on the tape deck to the TAPE outputs

(OUT) on this receiver.

This will allow you to make recordings from the

components connected to this receiver. Use

stereo RCA phono cables as shown.

Turntables only: Connect the audio

outputs of your turntable to the PHONO

inputs on this receiver.

• If your turntable has a grounding wire,

secure it to the ground terminal on this

receiver.

• If your turntable has line-level outputs (i.e.,

it has a built-in phono pre-amp), connect it

to the AUX inputs instead.

• Make sure the MM/MC switch is in the

proper position. If the sound of the

turntable seems loud and distorted, or

overly soft, try switching the setting.

Note

1 iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.

Connecting antennas

Connect the AM loop antenna and the FM wire

antenna as shown below. To improve reception

and sound quality, connect external antennas

(see Using external antennas below).

fig. a

FM UNBAL

Pull off the protective shields of both AM

antenna wires.

Push open the tabs, then insert one wire

fully into each terminal, then release the tabs

to secure the AM antenna wires.

Fix the AM loop antenna to the attached

stand.

To fix the stand to the antenna, bend in the

direction indicated by the arrow then clip the

loop onto the stand (fig. a).

• If you plan to mount the AM antenna to a

wall or other surface, secure the stand with

screws (fig. b) before clipping the loop to

the stand. Make sure the reception is clear.

fig. b

ANTENNA

AM LOOP