Pioneer AVH-3400NEX 설치 매뉴얼 - 페이지 7

{카테고리_이름} Pioneer AVH-3400NEX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVH-3400NEX 29 페이지. Dvd rds av receiver
Pioneer AVH-3400NEX에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)

페이지 인쇄

Dashboard

Mounting sleeve

Side bracket

Screw (2 mm × 3 mm)

DIN Rear-mount

Determine the appropriate position

where the holes on the bracket and

the side of the unit match.

When installing in a shallow space, use

the following screw holes.

Use binding screws (4 mm × 3 mm)

only.

Tighten two screws on each side.

Use any of binding screws (4 mm × 3

mm), binding screws (5 mm × 6 mm) or

flush surface screws (5 mm × 6 mm),

depending on the shape of screw holes

in the bracket.

Screw

Dashboard or console

Factory radio mounting bracket

NOTE

In some types of vehicles, discrepancy may

occur between the unit and the

dashboard. If this happens, use the

supplied frame to fill the gap.

Removing the unit

Extend top and bottom of the trim ring

outwards to remove the trim ring. And

then loosen the screws (2 mm × 3 mm) to

remove the mounting sleeve.

• When reattaching the trim ring, push the

trim ring onto the unit until it clicks. (If

the trim ring is attached upside down,

the trim ring will not fit properly.)

Mounting sleeve

Screw (2 mm × 3 mm)

Trim ring

Installing the

microphone

• Install the microphone in a place where

its direction and distance from the driver

make it easiest to pick up the driver's

voice.

• Be sure to turn off (ACC OFF) the product

before connecting the microphone.

• Depending on the vehicle model, the

microphone cable length may be too

short when you mount the microphone

on the sun visor. In such cases, install the

microphone on the steering column.

Mounting on the sun

visor

Fit the microphone lead into the

groove.

Microphone lead

Groove

Attach the microphone clip to the sun

visor.

Microphone clip

Clamps

Use separately sold clamps to secure

the lead where necessary inside the

vehicle.

Install the microphone on the sun visor

when it is in the up position. It cannot

recognise the driver's voice if the sun

visor is in the down position.

Installation on the

steering column

Detach the microphone base from the

microphone clip by sliding the

microphone base while pressing the

tab.

Tab

Microphone base

Mount the microphone on the

steering column.