Ariston A1235 사용 및 관리 및 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} Ariston A1235에 대한 사용 및 관리 및 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston A1235 16 페이지. Ariston washing machine use and care & installation instruction a1636s, a1636, a1436, a1235

Personalisation

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to cold wash (
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes
Cotton
Synthetics
Wool
Silk
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below.
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Function
Effect
Delays the start
of the wash by up
to 9 hours.
Delay Timer
Allows for an
impeccable wash,
visibly whiter
than a standard
Super Wash
Class A wash.
This option
reduces the
amount of
creasing on
Easy Iron
fabrics, making
them easy to
iron.
Cuts the duration
of the wash cycle
by 30%.
Rapid
Adds one extra
rinse cycle.
Extra Rinse
Maximum spin speed
1600rpm - Model A1636
800rpm
600rpm
no
Comments
Press the button repeatedly until the LED corresponding to the
desired delay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the START/RESET button, the
delay can only be decreased if you wish to modify it.
This function is incompatible with the RAPID function.
When this function is set, programmes 6, 7, 8, 11 and Delicate
rinse will end with the laundry left to soak (Anti-crease) and the
Rinse cycle phase LED
- to conclude the cycle, press the START/RESET button.
- to run the draining cycle alone, set the knob to the relative
symbol
and press the START/RESET button.
This function is incompatible with the SUPER WASH function.
Remember - you will use more water than with a standard
cycle.
).
1400rpm - Model A1436
will flash.
1200rpm - Model A1235
.
Enabled with
programmes
All
1, 2, 3, 5,
6, 7, 8.
All
programmes
except for 1,
2, 4, 9, 10
and Draining
1, 2, 3, 5,
6, 7, 8.
1, 2, 3, 4,
5, 6, 7, 8.
(Model
A1235 only)
7