Ariston A1237 지침 책자 - 페이지 10

{카테고리_이름} Ariston A1237에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston A1237 12 페이지. Ariston instruction manual washing maching a1637,a1437,a1237

페이지 인쇄

Care and maintenance

Switching off the water or electricity

Turn off the water tap after every wash. This will

limit the wear of your appliances water system and

also prevent leaks.

Unplug your appliance when cleaning it and during

all maintenance operations.

Cleaning

Cleaning the exterior

The exterior and rubber parts of your appliance can

be cleaned with a soft cloth soaked in lukewarm

soapy water. Do not use solvents or abrasives.

Cleaning the dispenser drawer and compartments

Cleaning the pump

! Not applicable to Model A1637 as it has an integrated

filter system.

Your appliance is fitted with a self-cleaning pump that

does not require any maintenance.

Sometimes, small items (such as coins or buttons) may

fall into the pre-chamber that protects the pump.

! Make sure the wash cycle has ended and unplug the

appliance.

4. Refit by screwing the filter into place until it reaches

its 'stop' position.

5. Refit the kickstrip, making sure that the hooks are

securely in place before you push it onto the appliance.

Remove the dispenser by

raising it and pulling it out

(see figure).

Wash it under running

water; this operation

should be repeated

frequently.

(Models A1437 & A1237 only):

To access the chamber:

1. Remove the kickstrip, on the

lower front of the appliance, by

holding at each end and pulling

towards you (see figure).

2. Unscrew the pump filter by

rotating it anti-clockwise, until it

can be removed (see figure).

A little water may leak from the

pump: this is perfectly normal.

3. Clean the interior thoroughly,

removing any visible debris.

Caring for your appliance door and drum

Always leave the appliance door ajar to prevent

unpleasant odours from forming.

Checking the water inlet hose

Check the water inlet hose at least once a year. If you

see any cracks, replace it immediately: during the

wash cycles, high water pressure could cause a

cracked hose to split open.

! Never use hoses that have already been used.

Moulded plug

! The plug must not be used

without the fuse cover in place.

If a replacement fuse

holder/cover is required, it must

be of the same colour coding or

wording as shown on the base of

the plug.

Replacements are available from

authorised dealers.

Changing the plug

The wires in the power cord are coloured in accordance

with the following:

Green and Yellow

(Earth) wire to terminal

marked 'E', symbol

or coloured green and

yellow.

Blue (Neutral) wire to

terminal marked 'N' or

coloured black.

Cord clamp

! If the plug being replaced is a non-rewirable type,

then the cut-off plug must be disposed of safely.

DO NOT leave it where it can be inserted into a socket

and create a shock hazard.

! The power supply cord should be checked periodically

and replaced by a cord specially prepared for this

machine and fitted only by authorised technicians (see

Service). New or longer power cords are supplied at

an extra charge by authorised dealers.

! The manufacturer denies any responsibility should

any of these rules not be followed.

! If in doubt about any of the above consult a

qualified electrician.

13A ASTA approved

fuse to BS1362.

Brown (Live) wire to

terminal marked 'L' or

coloured red.