Pioneer VSX-532 사용 설명서 - 페이지 16

{카테고리_이름} Pioneer VSX-532에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSX-532 39 페이지.

페이지 인쇄

Basic Setup

Automatically setting up for surround sound

(MCACC)

Place the supplied setup microphone in the listening position,

measure the test tones emitted by the speakers, then the unit

automatically sets the optimum volume level for each

speaker, the crossover frequencies, and the distance from

the listening position. This also enables correction of

distortion caused by the acoustic environment of the room.

CAUTION

The test tones used in the Full Auto MCACC setup are

•

output at high volume.

Important

•

The OSD will not appear if you have connected using the

composite output to your TV. Use HDMI connection for

Full Auto MCACC setup.

•

The Full Auto MCACC setup will overwrite any existing

speaker settings you've made.

•

Before using the Full Auto MCACC setup, the USB input

should not be selected as an input source.

ADJUST

RECEIVER

AUDIO SEL

HOME

DVD

SAT

STREAM BOX

TOP

CBL

S.BOX

Switch on the receiver and your TV.

Switch the TV input to the input that connects this

receiver to the TV through the corresponding HDMI

cable.

Connect the microphone to the SETUP MIC jack on the

front panel.

Make sure there are no obstacles between the speakers

and the microphone.

VOLUME

MUTE

RETURN

USB

If you have a tripod, use it to place the microphone so

that it's about ear level at your normal listening position.

Otherwise, place the microphone at ear level using a

table or a chair.

AUX INPUT

SETUP MIC

Press

button on the remote control to switch to BD/

DVD entry.

HOME MENU

Press

button.

The Home Menu appears on your TV. Use

ENTER

and

on the remote control to navigate through

the screens and select menu items. Press

exit the current menu.

HOME MENU

Press

at any time to exit the Home

•

Menu. If you cancel the Full Auto MCACC setup at

any time, the receiver automatically exits and no

settings will be made.

•

The screensaver automatically starts after three

minutes of inactivity.

Select "Full Auto MCACC" from the Home Menu, then

press ENTER.

Home Menu

1.Full Auto MCACC

2.Manual SP Setup

3.Input Assign

4.Auto Power Down

5.HDMI Setup

Return

ENTER

Press

again.

•

Mic In! blinks when the microphone is not connected

SETUP MIC

jack.

Try to be as quiet as possible after pressing ENTER.

The system outputs a series of test tones to establish the

ambient noise level.

Follow the instructions on-screen.

•

Make sure the microphone is connected.

•

Make sure the subwoofer is on and the volume is

turned up.

•

See below for notes regarding background noise and

other possible interference.

///

RETURN