Pioneer VSX-9500S VSX-7500S 사용 설명서 - 페이지 45
{카테고리_이름} Pioneer VSX-9500S VSX-7500S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSX-9500S VSX-7500S 48 페이지.
Pioneer VSX-9500S VSX-7500S에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)
페이지 인쇄
HINTS FOR BETTER RECEPTION
OUTDOOR FM ANTENNA
The main advantage of FM over AM is the quality of the broadcast
signal, in order to benofit fully from the high signal quality of FM
5, it is recommended that a special-purpose FM antenna be
element,
broade
installed. In weak signal areas, a multi-clement (3-element,
7-element) antenna should be used.
GROUNDING
Grounding is recommended if reception of FM programs is impaired by
noise.
To ground, connect a thick polyviny! insulated wire to the GND
terminal and attach the other end to a metal water pipe or grounding
bar or wind it around a copper plate and bury it.
NOTE:
Never connect a wire to a gas pipe for grounding since sparks may ignite
the gas.
EXTERNAL AM ANTENNA
{f it is not possible to obtain adequate AM reception even by changing
the orientation of the AM loop antenna, a separate indoor antenna, or
an outdoor antenna should be installed.
INDOOR AM ANTENNA
Use a vinyl insulated wire (5 -- 6 m} and connect one end to the AM
antenna terminal and affix the other end to the wall or ceiling, as high
as possible.
OUTDOOR
AM ANTENNA
f reception quality is not improved sufficiently even when an indoor
antenna is used, a vinyl insulated wire should be installed outside and
fixed in place.
NOTE:
Do not detach the AM loop antenna when using an indoor or an outdoor
AM antenna.
Connecting
8 coaxial 752 cable
iS]
Multielement FM outdoor antenna
ee
Ee
F type jack
Connecting a
3OOY feeder
on] GROUND
~
FM outdoor antenna
3002
feeder
Outdoor AM antenna
CN
ed
ok
)
| Te) + crouno
—_,
3)
/ AM loop antenna
a)
/
The RF modulator JA-RF5 is only required when using a conventional
TV set which does not have a video input terminal.
CHANNEL
= TV ANT
30M
4CH
TV VIDEO
\
Rear view
Liv ANT selector switch:
TV
ANT
(VHF OUT)
(VHF IN}
Front
ANTENNA
input terminal:
* Connect to the coaxial cable of a VHF TV
antenna.
ei if your
VHF
TV
antenna
is already
connected to a video disc player or VCR,
this terminal may be connected to the RF
output (VHF OUT) terminal of the video
disc player or VCR unit used.
RF output terminal:
Connect to the VHF
antenna
terminal
of
your television set.
Normally leave set to the VIDEO side.
CHANNEL
selector switch:
Set to 3 CH or 4 CH the empty channel in
your area.
Connector:
Connect to the 'TO
RF MODULATOR"
jack on the rear panel of a receiver.
45
<ARB1173>