Pioneer VSX-D309 사용 설명서 - 페이지 18

{카테고리_이름} Pioneer VSX-D309에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSX-D309 48 페이지. Audio/video multi-channel receiver

Preparations

Dynamic range is the difference between the loudest and softest sounds in any given signal. The dynamic range

control helps you play back sounds so the quieter sounds are audible yet the louder sounds don't get distored. It

does this by compressing the dynamic range. When watching a movie at low volume, setting this function

enables low level sounds to be heard more easily but you won't be jolted by lounder sounds.

• Initial setting is "OFF".

memo

• When the volume level is increased, set to OFF.

• For listening enjoyment at low volumes, set to "MAX" for maximum dynamic range

compression.

• Dynamic range control is effective only when a Dolby Digital signal is being played back.

Dual mono setting

The dual mono setting can only be used when listening to Dolby Digital discs that have dual mono software

encoded in them. With this setting you can choose which channel in the dual mono setting you want to listen to.

Thus, it is useful for soundtracks that have one language on one channel and a different language on the other.

Remember you can only use this setting if you have Dolbly Digital software with this feature and want to isolate

one of the channels therein. Otherwise, just ignore this function.

There are two different ways to route the sound in the dual mono setting, one is with Dolby Digital on, the other

with Dolby Digital off. If Dolby Digital is switched on, the ch1 setting will play ch1 through your center speaker.

The ch2 setting will play ch2 though your center speaker and the MIX setting will play both channels through the

center speaker. With Dolby Digital off, the dual mono sound routing is as follows: In the ch1 setting your will

hear channel 1 out of both front speakers. In the ch2 setting you will hear channel 2 out of both speakers. In the

L. c1 R. c2 setting the speakers will play the soundtrack independently of each other. The left front speker will

play channel 1 and the right front speaker will play channel 2. The last setting, MIX, mixes both channels and

plays them out of both speakers .

memo

• The default setting of this feature is L C 1 R C 2.

L. c 1 R. c 2

MIX

ch2

Sets the input component to be assigned to the coaxial digital input jack.

memo

• Initial setting is "DVD".

Press % or ﬁ to set the dynamic range control

(OFF, MAX, or MID).

Press % or ﬁ to cycle through the possible DUAL

MONO settings.

ch1

Press % or ﬁ to select the coaxial digital input

(DVD, TV, CD, CD-R, VCR, DV-R or OFF).

After you assign the component to a digital jack, like coaxial one,

whenever you select that component, for example CD, the receiver will

automatically change to the digital input setting. You can see this in the

DIGITAL/ANALOG indicator on the front of the receiver.