Pioneer VSX-D411 사용 설명서 - 페이지 38

{카테고리_이름} Pioneer VSX-D411에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSX-D411 44 페이지. Audio/video multi-channel receiver
Pioneer VSX-D411에 대해서도 마찬가지입니다: 서비스 매뉴얼 (4 페이지)

페이지 인쇄

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Sometimes the trouble may lie in

another component. Investigate the other components and electrical appliances being used. If the

trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer

authorized service center or your dealer to carry out repair work.

Problem

The power does not turn on.

No sound is output when a

function is selected.

No image is output when a

function is selected.

Considerable noise in radio

broadcasts.

Broadcast stations cannot be

selected automatically.

Remedy

• Connect the power plug to the wall outlet.

• Disconnect the power plug from the outlet, and insert again.

• Make sure there are no loose strands of speaker wire touching

the rear panel. This could cause the receiver to shut off auto-

matically.

• Make sure the component is connected correctly (refer to

pages 11–16).

• Press MUTE on the remote control to turn muting off.

• Adjust the MASTER VOLUME.

• Press the MONITOR button to turn monitoring off.

• Make sure the component is connected correctly (refer to

pages 11–13).

• Select the correct component (use the INPUT SELECTOR

buttons).

• Tune in the correct frequency.

• Connect the antenna (refer to pages 14–15).

• Route 2 RF and digital cables away from the antenna

terminals and wires.

• Fully extend the FM wire antenna, position for best reception,

and secure to a wall.

• Connect an outdoor FM antenna (refer to page 15).

• Adjust the direction and position for best reception.

• Connect an additional internal or external AM antenna (refer

to pages 14–15).

• Turn off the equipment causing the noise or move it away from

the receiver.

• Place the antenna farther away from the equipment causing

the noise.

• Connect an outdoor antenna (refer to page 15).