Pioneer A-502R 사용 설명서 - 페이지 7

{카테고리_이름} Pioneer A-502R에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A-502R 13 페이지.

페이지 인쇄

CONNECTIONS

Make all connections after unplugging AC cords.

CONNECTING THE SPEAKER CORDS

1. Strip off the vinyl covering and twist the tip of the

wire core.

Twist the wire core.

2. Loosen the knob and insert the wire core into the

terminal hole.

3. Tighten the knob to fix the wire core in place.

@ Lg

NOTE:

Do not allow the wire core to protrude and touch other terminals or

wires. lf the cores of differing wires touch, damage may be caused to

your amplifier and/or speaker systems.

Speaker Impedance

When the speaker systems are connected to only SPEAKERS A or

SPEAKERS

8B terminals,

such

speakers

should

have

rated

impedance in the range of 4 — 16 Q.

When speaker systems are connected to both the A and B terminals,

they should have a rated impedance in the range of 8 — 32 Q.

CONNECTING THE INPUT/OUTPUT CORDS

Connect the white plug to the L (left) channel, and the red plug to the

R (right) channel. Be sure to insert the plugs securely.

The INPUT/OUTPUT jacks of this unit are tinplated, for high audio

quality.

Right channel

—~

Red plug

TO USE THE COMPONENT CONNECTED TO

THE ADAPTOR TERMINALS

1. Set POWER switch to OFF.

2. Remove

the two shorting bars from ADAPTOR

terminals.

Shorting bars

NOTE:

Remove the shorting bars before connecting an equalizer to these

terminals. Always keep the bars inserted while the terminals are not

in use, and take care not to lose them.

REMOTE CONTROL CORD CONNECTIONS

By interconnecting the CONTROL jacks of Pioneer units with the

mark, the entire system can be operated with this remote control

unit, although some of the units (FM/AM tuner, CD player, cassette

deck, etc.) may not be equipped with remote sensors. The entire

system can be operated by a remote control unit connecting

PIONEER stereo components to each other using the control input

(CONTROL IN) jack on each component. Use the remote control cord

supplied with the respective unit for the connection. As long as you

connect "OUT" to "IN", the connecting sequence is arbitrary. In case

of a unit which has only an "IN" connector, connect it last.

@® Remote control unit

@ Cassette deck

CD player

@ FM/AM tuner