Pioneer CX-J400 사용 설명서 - 페이지 31

{카테고리_이름} Pioneer CX-J400에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer CX-J400 35 페이지. Tuner control amplifier amplificateur de commande tuner / stereo power amplifier amplificateur de puissance stereo / sound image controller controleur d'image sonore / stereo double cassette tape deck double platine cassette stereo / auto-return stereo tu
Pioneer CX-J400에 대해서도 마찬가지입니다: 사용 설명서 (36 페이지)

페이지 인쇄

| TROUBLESHOOT

lo carry out repair work,

service center of your dealer

Symptom

Cause

Remedy

power switch is ON (when the

i No power is supplied even when

control amplifier's power switch

is OFF, the entire system is OFF}.

* Power plug is not connected to wall outlet.

* Connecting cabies are not connected securely or

properly.

* Plug in the power plug securely.

* Refer to the connection section and make the

proper cable connections.

No sound from speakers.

* Cables are disconnected from their connectors,

or connected improperly.

* Sound volume is set at MIN.

° Speaker cords are not connected.

* Speaker cords were connected without removing

the viny! insulation,

* The amplifiers FUNCTION position is not set

properly for the source you wish to listen to.

* Disconnect the power plug from the wall outlet

and reconnect all cables properly.

* Use the volume contro! to set the vafume

appropriately.

* Connect the speaker cords properly.

* Strip the viny! insulation from the end of the

cords and reconnect them to the speaker cords.

* Set the FUNCTION

properly.

Sound is heard from one side

only,

* One of the speaker's cords is disconnected or

cut.

* Connect the speaker cords securely to their

connectors, or replace with good cords.

CASSETTE DECK FUNCTIONS

The cassette deck's door does

not open.

* The deck is not in the stop mode.

* The unit's power was turned OFF while the tape

was running.

* Press the STOP button (i).

* Turn on the power again.

The cassette deck's door does

not close.

* The tape cassette is not inserted properly.

* Insert the tape cassette properly,

The cassette tape does not run,

* The tape cassette is not inserted property.

* Insert the tape cassette properly in the cassette

holder.

Tape sound can not be heard.

* The FUNCTION is not set to TAPE.

* A non-recorded tape has been loaded.

* Set FUNCTION

to TAPE.

* Replace with a prerecorded tape.

—

Recording not possible.

* The cassette tape's erasure prevention tab is

* Exchange with a new tape, or cover the erasure

broken.

prevention tab holes with cellophane tape.

The cassette deck's connection with the tuner contro!

amplifier is disconnected or not connected properly.

* The amplifiers recording source selection is not

set properly.

* The deck's recording/playback heads are dirty.

* Check all connections.

* Perform operations in accordance with the

procedures given in the section "Recording onto

A Cassette Tape.'

* Clean the recording/playback heads.

the previous recorded sounds

can still be heard on the tape.

When a new recording is made,

.* Recording/playback heads are dirty.

* Clean the recording/playback heads.

Can not copy a tape.

* A cassette tape is joaded in only one of deck |

and deck If.

* The cassette tape loaded in deck I! has its

erasure prevention tab broken.

* Cassette tapes must be loaded properly in both

decks.

* Replace with a tape whose erasure prevention

tab has not been broken.

Sound is muddy, or reduced in

volume.

* Recording/playback heads are dirty.

* A tape recorded without Dolby NR is being

played back with the Dolby NR switch B or C in

the ON position.

| * Set the Dolby NR switch to OFF,

* Clean the recording/playback heads.

High-frequency sounds are

overly emphasized.

* A tape recorded with Dolby NR type B or C is

being played back with the Dolby NR switch in

the OFF position.

* Set the Dolby NR switch to the B or C position

@S appropriate.

{In the CT-J200WR, set to the ON position.)

Abnormal sounds (humming or

whistling) are heard when

listening to tapes, CD, or radio

broadcasts, and those sounds

are recorded on cassette tape

L recordings.

* Your television's switch is ON when listening to

music.

* This unit is located too close to your television.

* You are trying to use high speed copying.

* Turn your television OFF.

* Set your television farther away from this unit.

* Try copying at normal speed.