Pioneer DC-Z85 사용 설명서 - 페이지 19

{카테고리_이름} Pioneer DC-Z85에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DC-Z85 28 페이지. Stereo double cassette deck amplifier / fm/am digital synthesizer tuner / stereo turntable

페이지 인쇄

| MICROPHONE MIXING

| COPYING TAPES

Mixing

involves combining the signals from two input sources (a

microphone and a

oe, for exemple).

[ MIXING PROCEDURE _

1, Plug a microphone

inte MIC jack

2. Adjust VOLUME

to a suitable level.

3. Set MIC LEVEL contro! to the center position between MIN

and MAX.

elf howling occurs (a high-pitched sound from the speakers),

take the following

steps

1. Move the microphone away from the speakers.

2. Lower the volume

Select the desired program source using input selector but-

tons

5. Start playback of the program source.

6. Adjust VOLUME

control.

Use MIC LEVEL control to adjust the microphone level in rela-

tion to the music source,

8. Talk or sing into the microphone.

[ MIXING RECORDING

" ee

You can use the mixing feature to record together an input from a

microphone and another

source

Perform steps 1 to 7 in the section "MIXING PROCEDURE."

Load a tape for recording into deck H.

Press REC ( @ ) button on deck #.

Press PLAY { ® or ~€) button on deck Hl.

. Sing along with the program source.

NOTE:

When microphone mixing while playing back an Deck |, mixing recor-

ding is not possible

on Deck It

TRONS

CASSETTE TAPE RELAY PLAYBACK

@ When there are tapes in both Deck | and Deck Il, relay play from

Deck | to Deck Il is possible

® Relay playback is repe

as follows:

Deck | forward play ( # ) - - Deck | reverse pl

<4)

Deck If reverse play (@)

— Deck li forward play (

) ——

® If there is a tape in only one of the decks, then it will be played con-

tinuously on both sides.

1. Load the playback tapes into deck | and deck Ul.

2. Set DOLBY NR switch to the same position used for recor-

ding.

3. Press the appropriate PLAY switch ( * or

1) on deck I.

4. To stop relay playback, press STOP switch ( @ ) of the opera-

ting deck.

Duplicating the

recorded contents of one tape onto another tape

known as tape

copying. The

contents of the tape in d:

pied onto the

iape in deck ll {but not vice versa.) Copying

vot

possible while eith

operating. You cannot record a source

using the sound image controller.

loan be

If a tape recorded with the DOLBY NK system is copied, the ¢

pied tape will also be recorded automatically with DOLBY NR sys:

tem. If a tape recorded without the DOLBY NR system is copied.

the copied tape will also be recorded automatically without the

DOLBY NR system.

1. Load the recorded tape into deck | and the tape for recording

into deck Hl.

netic coating portion.

® Tape copying begins from the forward direction | ® )

® Both sides are copied from deck | to deck I

® Make sure there is no tape sla

2. To perform a normal copy while listening to playback, set

input selector button on the amplifier to TAPE and select the

DOLBY NR switch position.

| Even if input selector button is set to another position

ing will still proceed. The sound of the program source

by input selector button will be heard through th

3. Press one of SYNCHRO COPY | » II buttons.

NORMAL: for tape copying at normal speed while

HIGH: for tape copying at about twice normal speed

4. Press STOP button ( M) on either deck to stop the copying at

any time.

NOTE:

° /fyou are using a TVin the vicinity

of the unit, noise will be recarded,

Either switch off the TV or move it away from the unit.

® There is variation in actual tape length even among

cassettes

of the

same length label (C-60, C-90, etc.}. Therelare, even if the

recording

tape is labeled as the same length as the playback tajze, itis possible

for the recording tape to end first without recording. all af the con

tents of the playback tape.