Pioneer Elite M-10X 사용 설명서 - 페이지 3

{카테고리_이름} Pioneer Elite M-10X에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite M-10X 12 페이지. Operating instructions
Pioneer Elite M-10X에 대해서도 마찬가지입니다: 사양 시트 (1 페이지), 사용 설명서 (36 페이지), 서비스 매뉴얼 (22 페이지)

페이지 인쇄

IMPORTANT SAFETY INSTRUCTIONS

READ INSTRUCTIONS — All the safety

and operating instructions should be

read before the product is operated.

RETAIN INSTRUCTIONS — The safety and

operating instructions should be retained

for future reference.

HEED WARNINGS — All warnings on the

product and in the operating instructions

should be adhered to.

FOLLOW INSTRUCTIONS — All operating

and use instructions should be followed.

CLEANING — Unplug this product from the

wall outlet before cleaning. The product

should be cleaned only with a polishing

cloth or a soft dry cloth. Never clean

with furniture wax, benzine, insecticides

or other volatile liquids since they may

corrode the cabinet.

ATTACHMENTS — Do not use attachments

not recommended by the product

manufacturer as they may cause

hazards.

WATER AND MOISTURE — Do not use

this product near water — for example,

near a bathtub, wash bowl, kitchen sink,

or laundry tub; in a wet basement; or

near a swimming pool; and the like.

ACCESSORIES — Do not place this product

on an unstable cart, stand, tripod,

bracket, or table. The product may fall,

causing serious injury to a child or adult,

and serious damage to the product. Use

only with a cart, stand, tripod, bracket,

or table recommended by the

manufacturer, or sold with the product.

Any mounting of the product should

follow the manufacturer's instructions,

and should use a mounting accessory

recommended by the manufacturer.

CART — A product and cart combination

should be moved with care. Quick stops,

excessive force, and uneven surfaces

may cause the product and cart

combination to overturn.

VENTILATION — Slots and openings in the

cabinet are provided for ventilation and

to ensure reliable operation of the

product and to protect it from

overheating, and these openings must

not be blocked or covered. The openings

should never be blocked by placing the

product on a bed, sofa, rug, or other

similar surface. This product should not

be placed in a built-in installation such

as a bookcase or rack unless proper

ventilation is provided or the

manufacturer's instructions have been

adhered to.

POWER SOURCES — This product should

be operated only from the type of power

source indicated on the marking label. If

you are not sure of the type of power

supply to your home, consult your

product dealer or local power company.

LOCATION – The appliance should be in-

stalled in a stable location.

NONUSE PERIODS – The power cord of

the appliance should be unplugged from

the outlet when left un-used for a long

period of time.

GROUNDING OR POLARIZATION

If this product is equipped with a

polarized alternating current line plug (a

plug having one blade wider than the

other), it will fit into the outlet only one

way. This is a safety feature. If you are

unable to insert the plug fully into the

outlet, try reversing the plug. If the plug

should still fail to fit, contact your

electrician to replace your obsolete

outlet. Do not defeat the safety purpose

of the polarized plug.

If this product is equipped with a three-

wire grounding type plug, a plug having

a third (grounding) pin, it will only fit into

a grounding type power outlet. This is a

safety feature. If you are unable to insert

the plug into the outlet, contact your

electrician to replace your obsolete

outlet. Do not defeat the safety purpose

of the grounding type plug.

POWER-CORD PROTECTION — Power-

supply cords should be routed so that

they are not likely to be walked on or

pinched by items placed upon or against

them, paying particular attention to cords

at plugs, convenience receptacles, and

the point where they exit from the

product.

OUTDOOR ANTENNA GROUNDING — If

an outside antenna or cable system is

connected to the product, be sure the

antenna or cable system is grounded so

as to provide some protection against

voltage surges and built-up static

charges. Article 810 of the National

Electrical Code, ANSI/NFPA 70, provides

information with regard to proper

grounding of the mast and supporting

structure, grounding of the lead-in wire

to an antenna discharge unit, size of

grounding conductors, location of

antenna-discharge unit, connection to

grounding electrodes, and requirements

for the grounding electrode. See Figure

LIGHTNING — For added protection for this

product during a lightning storm, or when

it is left unattended and unused for long

periods of time, unplug it from the wall

outlet and disconnect the antenna or

cable system. This will prevent damage

to the product due to lightning and

power-line surges.

POWER LINES — An outside antenna

system should not be located in the

vicinity of overhead power lines or other

electric light or power circuits, or where

it can fall into such power lines or circuits.

When installing an outside antenna

system, extreme care should be taken

to keep from touching such power lines

or circuits as contact with them might

be fatal.

OVERLOADING — Do not overload wall

outlets, extension cords, or integral

convenience receptacles as this can

result in a risk of fire or electric shock.

ELECTRIC

SERVICE

EQUIPMENT

Fig. A

OBJECT AND LIQUID ENTRY — Never

push objects of any kind into this product

through openings as they may touch

dangerous voltage points or short-out

parts that could result in a fire or electric

shock. Never spill liquid of any kind on

the product.

SERVICING — Do not attempt to service

this product yourself as opening or

removing covers may expose you to

dangerous voltage or other hazards.

Refer all servicing to qualified service

personnel.

DAMAGE REQUIRING SERVICE — Unplug

this product from the wall outlet and

refer servicing to qualified service

personnel under the following

conditions:

When the power-supply cord or plug is

damaged.

If liquid has been spilled, or objects

have fallen into the product.

If the product has been exposed to rain

or water.

If the product does not operate normally

by following the operating instructions.

Adjust only those controls that are

covered by the operating instructions

as an improper adjustment of other

controls may result in damage and will

often require extensive work by a

qualified technician to restore the

product to its normal operation.

If the product has been dropped or

damaged in any way.

When the product exhibits a distinct

change in performance — this indicates

a need for service.

REPLACEMENT

PARTS

replacement parts are required, be sure

the service technician has used

replacement parts specified by the

manufacturer or have the same

characteristics as the original part.

Unauthorized substitutions may result

in fire, electric shock, or other hazards.

SAFETY CHECK — Upon completion of any

service or repairs to this product, ask

the service technician to perform safety

checks to determine that the product is

in proper operating condition.

WALL OR CEILING MOUNTING — The

product should not be mounted to a

wall or ceiling.

HEAT — The product should be situated

away from heat sources such as

radiators, heat registers, stoves, or other

products (including amplifiers) that

produce heat.

ANTENNA

LEAD IN

WIRE

GROUND

CLAMP

ANTENNA

DISCHARGE UNIT

(NEC SECTION 810-20)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250, PART H)

NEC — NATIONAL ELECTRICAL CODE

—

When