Pioneer Elite M-10X 서비스 매뉴얼 - 페이지 22
{카테고리_이름} Pioneer Elite M-10X에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite M-10X 22 페이지. Operating instructions
Pioneer Elite M-10X에 대해서도 마찬가지입니다: 사양 시트 (1 페이지), 사용 설명서 (36 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
M-10X
SPECIFICATIONS
For KU/CA Type
Amplifier Section
Continuous average power output of 100
watts* per channel, min., at 4 ohms, from 20
Hz to 20,000 Hz with no more than 0.2 %**
total harmonic distortion.
Puissance de sortie moyenne continue de
100 watts* par canal, minimum, sous 4
ohms, de 20 Hz à 20.000 Hz avec distorsion
harmonique totale inférieure à 0,2 %**.
Continuous power output
(both channels driven at 20 Hz to 20 kHz)**
T.H.D. 0.2 %, 4 Ω .......................... 100 W + 100 W
T.H.D. 0.2 %, 8 Ω .............................. 70 W + 70 W
Total harmonic distortion**
20 Hz to 20 kHz, 8 Ω .................................... 0.05 %
Input sensitivity/ impedance ........... 700 mV/ 47 kΩ
Frequency response ............ 5 Hz to 100 kHz
Signal-to-Noise ratio (IHF A network, short circuit)
.............................................................. 118 dB
Power Supply/ Miscellaneous
Power requirements ................ AC 120 Volts, 60 Hz
Power consumption ....................................... 198 W
Power consumption in standby mode ............. 1 W
Consommation (en veille) ................................. 1 W
Dimensions ........... 420 (W) × 319 (D) × 128 (H) mm
(including knobs and other protruding parts)
Weight (without package) .............................. 7.6 kg
Accessories
Operating instructions ............................................ 1
Power cord (Rated current 7 A) ............................. 1
Remote control cord ............................................... 1
Warranty card .......................................................... 1
NOTE:
Specifications and design subject to possible modification
without notice, due to improvements.
* M e a s u r e d p u r s u a n t t o t h e F e d e r a l Tr a d e
Commission's Trade Regulation rule on Power Output
Claims for Amplifiers.
** Measured by Audio Spectrum Analyzer.
22
For MY Type
Amplifier Section
Continuous power output
(both channels driven at 20 Hz to 20 kHz)*
T.H.D. 0.09 %, 4 Ω ............................................... 90 W + 90 W
T.H.D. 0.05 %, 8 Ω ............................................... 60 W + 60 W
DIN Continuous power output (both channels driven at 1 kHz)
T.H.D. 1.0 %, 4 Ω ............................................. 120 W + 120 W
T.H.D. 1.0 %, 8 Ω ................................................. 75 W + 75 W
Total harmonic distortion*
20 Hz to 20 kHz, 8 Ω ...................................................... 0.05 %
•Power output specification is for when power supply is 230V.
Input sensitivity/ impedance ................................. 700 mV/ 47 kΩ
Frequency response ................................... 5 Hz to 100 kHz
Signal-to-Noise ratio (IHF A network, short circuit)
........................................................................................ 118 dB
Power Supply/ Miscellaneous
Power requirements ...................... AC 220 – 230 Volts, 50/ 60 Hz
Power consumption ............................................................. 220 W
+0
dB
–3
Power Consumption in standby mode ................................... 1 W
Dimensions ................................ 420 (W) × 319 (D) × 128 (H) mm
(including knobs and other protruding parts)
Weight (without package) ................................................... 7.6 kg
Accessories
Operating instructions ................................................................. 1
Power cord (Rated current 2.5 A) ................................................ 1
Remote control cord .................................................................... 1
Warranty card ............................................................................... 1
NOTE:
Specifications and design subject to possible modification without
notice, due to improvements.
*
Measured by Audio Spectrum Analyzer.
+0
dB
–3