Pioneer GM-3500T 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Pioneer GM-3500T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-3500T 45 페이지. Bridgeable two-channel power amplifier
Pioneer GM-3500T에 대해서도 마찬가지입니다: 소유자 매뉴얼 (37 페이지), 소유자 매뉴얼 (14 페이지)

Pioneer GM-3500T 소유자 매뉴얼
Section
03
Connecting the units

About bridged mode

Speaker impedance is max. 4 W, please carefully
check. Improper connection to the amplifier may
result in malfunction or personal injury due to
burns from overheating.
For bridged mode for a two-channel amplifier,
with a 4 W load, either wire two 8 W speakers in
parallel, Left + and Right * (Diagram A) or use a
single 4 W speaker. For other amplifiers, please
follow the speaker output connection diagram for
bridging shown on rear: two 8 W speakers in par-
allel for a 4 W load or a single 4 W speaker per
channel.
For any further enquiries, contact your local
authorized Pioneer dealer or customer service.
About suitable
specification of speaker
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
to 8 W for stereo connection, or 4 W to 8 W for
monaural and other bridge connection.
Subwoofer
Speaker channel
Two-channel output
One-channel output
6
En
Power
Nominal input:
Min. 60 W
Nominal input:
Min. 180 W
Other than subwoofer
Speaker channel
Power
MAX input:
Two-channel output
Min. 120 W
MAX input:
One-channel output
Min. 370 W

Connecting the speakers

The speaker output mode can be two-channel
(stereo) or one-channel (mono). Connect the
speaker leads to suit the mode according to
the figures shown below.
Two-channel output (Stereo)
1 Speaker (Left)
2 Speaker (Right)
One-channel output
1 Speaker (Mono)
1
2
1