Pioneer GM-6100F 서비스 매뉴얼 - 페이지 26
{카테고리_이름} Pioneer GM-6100F에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-6100F 28 페이지. Bridgeable four-channel
Pioneer GM-6100F에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지), 소유자 매뉴얼 (6 페이지)
페이지 인쇄
1
QQ
3 7 63 1515 0
Removing the Amp Unit (Fig. 3)
A
1
Remove six black screws (M3 x 10).
2
Remove six white screws (M3 x 12).
A
Screw holes in the PCB are printed with
numbers 1 to 12.
Remove screws in numerical order.
Re-assembly takes the reverse order of
B
disassembly.
Caution)
The Amp Unit is adhered on the Heat Sink with
silicon grease. This means forcibly removing the
Amp Unit from the Heat Sink may break the
PCB.
Remove all of the twelve screws. Then,
remove the two black screws (M3 x 5).
3
Tighten screws whose length is M3 x 8 or
more into the two screw holes so as to
C
raise the Amp Unit above the Heat Sink.
Then, remove the Amp Unit.
(Since screw threads differ,
TE
L 13942296513
Caution when re-assembling the Amp Unit and the Heat Sink
Be aware that the RCA Terminal may break
unless the Amp Unit and the Heat Sink are
assem-bled following the correct procedures
given below.
1) Secure the RCA-side Panel on the Heat Sink
D
with screws. (Fig. 2)
2) Place the Amp Unit on the Heat Sink aligning
with two studs. (Fig. 4)
3) Move the Amp Unit until the RCA Holder on
the Amp Unit comes in contact with the inside
of the Panel. (Fig. 4)
Caution in steps 2) and 3)
When you place the Amp Unit on the Heat Sink,
you will find no positioning marks to determine
the direction of two panels. To position them
E
correctly, the Amp Unit needs to be moved to
the place where it comes in contact with the
RCA-side panel.
If you do not position them, an excessive force
can be applied to the RCA Terminal. This may
result in breakage.
4) Secure the RCA-side Panel and the RCA
www
Holder with screws. (Fig. 2)
5) Secure the Amp Unit on the Heat Sink with
the screws. (Fig. 3)
F
6) Secure the Panel for the Power Terminal side
in place with screws. (Fig. 2)
26
1
http://www.xiaoyu163.com
2
and
screws cannot be used.)
1
2
x
ao
y
.
i
GM-6100F/XU/EW
2
http://www.xiaoyu163.com
3
8
Amp Unit
1
2
2
1
Q Q
3
6 7
1 3
RCA Holder
RCA Terminal
(CN851,CN852)
Move the Amp Unit
Panel for the
RCA side
u163
Stud
.
3
4
2 9
9 4
2 8
Heat Sink
1
1
3
2
2
2
2
3
1
1
Fig. 3
1 5
0 5
8
2 9
9 4
Amp Unit
Heat Sink
m
co
Stud
Fig. 4
4
9 9
2 8
9 9