Pioneer GM-A3702 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Pioneer GM-A3702에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-A3702 16 페이지. Bridgeable two-channel
Pioneer GM-A3702에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (33 페이지), 소유자 매뉴얼 (33 페이지)

페이지 인쇄

1. Connecting the Speakers

Connecting the units

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

9 Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connecting

the speakers.

a Fuse 30 A × 2 (GM-A5702) / 25 A × 1 (GM-

A3702)

b Fuse (30 A) × 2

c Grommet

d Rear side

e Front side

Before connecting the

amplifier

WARNING

! Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

! Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

CAUTION

! Never shorten any wires, the protection circuit

may malfunction.

! Never wire the speaker negative cable directly

to ground.

! Never band together multiple speaker's nega-

tive cables.

! If the system remote control wire of the ampli-

fier is connected to the power terminal via the

ignition switch (12 V DC), the amplifier will re-

main on with the ignition whether the car

stereo is on or off, which may exhaust battery

if the engine is at rest or idling.

! Install and route the separately sold battery

wire as far as possible from the speaker wires.

Install and route the separately sold battery

wire, ground wire, speaker wires and the am-

plifier as far away as possible from the anten-

na, antenna cable and tuner.

Autogoods "130"