Pioneer GM-A5602 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Pioneer GM-A5602에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-A5602 11 페이지. Bridgeable two-channel power amplifier
Pioneer GM-A5602에 대해서도 마찬가지입니다: 소유자 매뉴얼 (45 페이지), 소유자 매뉴얼 (18 페이지), 소유자 매뉴얼 (49 페이지)

페이지 인쇄

1. About Bridged Mode

Section

Setting the unit

What's what

GM-A5602

Front side

Rear side

GM-A3602

Front side

Rear side

To adjust the switch, use a flathead screwdri-

ver if needed.

1 LPF (low-pass filter) switch

Switch the settings based on the connected

speaker.

! When the Subwoofer is connected:

Select ON. This eliminates high range

frequency and outputs low range fre-

quency.

! When the full range speaker is con-

nected:

Select OFF. OFF outputs the entire fre-

quency range.

2 FREQ (cut off frequency) control

Cut off frequency selectable from 40 Hz to

500 Hz if the LPF select switch is set to ON.

3 BASS BOOST (bass boost level control)

switch

You can select a bass boost level from 0 dB,

6 dB and 12 dB.

4 GAIN (gain) control

If output remains low, even when the car

stereo volume is turned up, turn controls to

lower level. If distortion occurs when the car

stereo volume is turned up, turn these con-

trols to higher level.

! For use with an RCA equipped car stereo

(standard output of 500 mV), set to the

NORMAL position. For use with an RCA

equipped Pioneer car stereo, with maxi-

mum output of 4 V or more, adjust level

to match that of the car stereo output.

! For use with an RCA equipped car stereo

with output of 4 V, set to the HIGH posi-

tion.

! If you hear too much noise when using

the speaker input terminals, turn the

gain control to higher level.

5 Power indicator

The power indicator lights up to indicate

power ON.

Setting gain properly

! Protective function included to prevent

malfunction of the unit and/or speakers

due to excessive output, improper use or

improper connection.

! When outputting high volume sound etc.,

this function cuts off the output for a few

seconds as a normal function, but output

is restored when the volume of the head

unit is turned down.