Pioneer GM-D7400M - Amplifier 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Pioneer GM-D7400M - Amplifier에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-D7400M - Amplifier 16 페이지. Class d mono amplifier
Pioneer GM-D7400M - Amplifier에 대해서도 마찬가지입니다: 소유자 매뉴얼 (6 페이지), 소유자 매뉴얼 (38 페이지), 서비스 매뉴얼 (31 페이지)
페이지 인쇄
Interior of
the vehicle
Drill a 13 mm
(112 in.) hole
into the vehi-
cle body.
Engine
compartment
Fuse (40A)x2 /
Insert the O-ring rubber
grommet into the vehicle
body.
Positive (+)
terminal
0
1
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive (+) terminal of
the battery.
2. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
Solderless Terminal Connections
• Do not connect a cord having an exposed core
wire to the power terminals of this amplifier
(Power terminal, GND terminal, System remote
control terminal). Disconnection or breakage of
the core wire can cause a fire or short-circuit.
• Since the wire will become loose over time, it
must be periodically inspected and tightened as
necessary.
• Do not solder or bind the ends of the twisted
WIres.
• Fasten while making sure to not to clamp the
insulating sheath of the wire.
• Use the supplied hexagonal wrench to tighten and
loosen the terminal screw of the amplifier.
Securely fasten the wire with the terminal screw.
However, since excessively tightening the termi-
nal screw of the System remote control has the
risk of damaging the wire, be careful not to tight-
en excessively by observing the status of the wire
when tightening.
Connecting the Power Terminal
• We recommend that you use the special red bat-
tery and ground wire [RD-228], which is sold
separately. Connect the battery wire directly to
the car battery positive terminal (+) and the
ground wire to the car body.
• Recommended wires size (AWG: American Wire
Gauge) is as follows. The battery wire and the
ground wire must be same size.
• Use a 10 AWG to 20 AWG wire for the system
remote control wire.
Battery Wire and Ground Wire Size
less than
less than
less than
5.7m
9.0m
14.4 m
less than
less than
less than
18 ft.
29 ft.
47 ft.
8AWG
6AWG
4AWG
System remote
Terminal screws
control terminal
~~;'"
GND terminal
Power
lennina!
~
r-----
~~~~tound
wire
B
.~ ~
attery WIre
System remote
control wire
4
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor bums.