Pioneer GM-D8701 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Pioneer GM-D8701에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-D8701 16 페이지. Class d mono amplifier
Pioneer GM-D8701에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Connecting the units

Route battery wire from engine com-

partment to the vehicle interior.

When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive + battery term-

inal.

1 Positive + terminal

2 Battery wire (sold separately)

The maximum length of the wire between

the fuse and the positive + terminal of the

battery is 30 cm (12 in.).

3 Fuse 100 A (GM-D8701 and GM-DX871) /

150 A (GM-D9701 and GM-DX971) (sold se-

parately)

Each amplifier must be separately fused at

100 A (GM-D8701 and GM-DX871) / 150 A

(GM-D9701 and GM-DX971).

Use wire cutters or a utility knife to

strip the end of the battery wire, ground

wire and system remote control wire to ex-

pose about 10 mm (3/8 in.) of the end of

each of the wires, and then twist the ex-

posed ends of the wires.

Connect the wires to the terminal.

Fix the wires securely with the terminal

screws.

Twist

10 mm (3/8 in.)

1 Battery wire

2 Power terminal

3 Ground wire

4 GND terminal

5 System remote control wire

6 System remote control terminal

7 Terminal screws