Pioneer GM-DX874 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Pioneer GM-DX874에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-DX874 16 페이지. Bridgeable four-channel power amplifier
Pioneer GM-DX874에 대해서도 마찬가지입니다: 서비스 매뉴얼 (17 페이지), 소유자 매뉴얼 (16 페이지)
페이지 인쇄
Connecting the units
The ground wires must be same size as the
battery wire.
Connect to metal body or chassis.
7 Car stereo with RCA output jacks (sold sepa-
rately)
8 External output
If only one input plug is used, do not connect
anything to RCA input jack B.
9 Connecting wire with RCA pin plugs (sold se-
parately)
a RCA input jack A
b RCA input jack B
c Amplifier with RCA input jacks (sold sepa-
rately)
d RCA output jack
Outputs the signal input to CH A.
e Speaker output terminals
Please see the following section for speaker
connection instructions. Refer to Connections
when using the speaker input wire.
f System remote control wire (sold separately)
Connect male terminal of this wire to the sys-
tem remote control terminal of the car stereo.
The female terminal can be connected to the
auto-antenna relay control terminal. If the car
stereo lacks a system remote control terminal,
connect the male terminal to the power term-
inal via the ignition switch.
g Fuse (30 A) × 2
h Front side
i Rear side
j Bass boost level remote control wire (5 m)
k Bass boost level remote control
Note
INPUT SELECT (input select) switch must be set.
For details, see Setting the unit.
Before connecting the
amplifier
WARNING
Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.
Never cut the insulation of the power supply
to feed power to other equipment. Current ca-
pacity of the wire is limited.
CAUTION
Never shorten any wires, the protection circuit
may malfunction.
Never wire the speaker negative cable directly
to ground.
Never band together multiple speaker s nega-
tive cables.
If the system remote control wire of the ampli-
fier is connected to the power terminal via the
ignition switch (12 V DC), the amplifier will re-
main on with the ignition whether the car
stereo is on or off, which may exhaust battery
if the engine is at rest or idling.
Install and route the separately sold battery
wire as far as possible from the speaker wires.
Install and route the separately sold battery
wire, ground wire, speaker wires and the am-
plifier as far away as possible from the anten-
na, antenna cable and tuner.
About bridged mode
En