Pioneer GM-X962 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Pioneer GM-X962에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-X962 18 페이지. Bridgeable power amplifier
Pioneer GM-X962에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)
페이지 인쇄
- 1. Before Using this Product
- 2. Composition of Manual
- 3. Setting the Unit
- 4. Connecting the Unit
- 5. Connection Diagram
- 6. Connecting the Power Terminal
- 7. Connecting the Speaker Terminals
- 8. Connecting the Speaker Wires
- 9. Two-Channel Mode (Stereo)
- 10. Component Guide
- 11. Example of Installation on the Floor Mat or on the Chassis
- 12. Specifications
- 13. Average Current Drawn
GM-X862
Power source .............................................................................................................. 14.4 V DC (10.8 — 15.1 V allowable)
Grounding system ............................................................................................................................................ Negative type
Current consumption ........................................................................................................ 25.0 A (at continuous power, 4 Ω)
Average current drawn* ............................................................................................................ 9.6 A (4 Ω for two channels)
Fuse .......................................................................................................................................................................... 25 A × 2
Dimensions ........................................................................................................................ 279 (W) × 61 (H) × 324 (D) mm
Weight ...................................................................................................... 5.0 kg (11.0 lbs) (Leads for wiring not included)
Maximum power output .................................................................................................................... 250 W × 2 / 760 W × 1
Continuous power output ........................................................ 125 W × 2 (at 14.4 V, 4 Ω, 20 — 20,000 Hz, 0.08% THD)
Load impedance ............................................................................................................................ 4 Ω (2 — 8 Ω allowable)
Frequency response ............................................................................................................ 10 — 50,000 Hz (+0 dB, –1 dB)
Signal-to-noise ratio ...................................................................................................................... 100 dB (IHF–A network)
Distortion ............................................................................................................................................ 0.008% (10 W, 1 kHz)
Separation ........................................................................................................................................................ 65 dB (1 kHz)
Low pass filter ................................................................................................................................ Cut off frequency: 80 Hz
Maximum input level/impedance .................................................................................... RCA: 6.5 V/22 kΩ (0.2 — 6.5 V)
Note:
• Specifications and the design are subject to possible modification without notice
due to improvements.
*Average current drawn
• The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.
[11 (W) × 2-3/8 (H) × 12-3/4 (D) in]
380 W × 1 (at 14.4 V, 4 Ω, 20 — 20,000 Hz, 0.8% THD)
190 W × 2 (at 14.4 V, 2 Ω, 20 — 20,000 Hz, 0.8% THD)
(Bridge connection: 4 — 8 Ω allowable)
17.3 A (4 Ω for one channel)
Cut off slope: –12 dB/oct