Pioneer Premier PRS-A900 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Pioneer Premier PRS-A900에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Premier PRS-A900 17 페이지. Bridgeable four-channel power amplifier
Pioneer Premier PRS-A900에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지), 서비스 매뉴얼 (41 페이지)

페이지 인쇄
Pioneer Premier PRS-A900 소유자 매뉴얼
•
Setting the Unit
Terminal Cover
~-----------------------i
Before setting up the unit, unfasten the screws with a 4 mm hexagonal
wrench and remove the terminal cover.
Badge
When you change the BFC switch or the direction of the badge, unfasten
the screws with a 2 mm hexagonal wrench and remove the badge. Be
careful not to lose the screws when fastening and removing.
BFC (Beat Frequency Control) Switch
If you hear a beat while listening to an AM broadcast with your car
stereo, change the BFC switch using a small standard tip screwdriver.
Power Indicator
The power indicator lights when the power is switched on.
Input Select Switch
For two-channel input, slide this switch to the left. For four-channel
input, slide this switch to the right.
Gain Control
Adjusting the gain controls A and B will help match the output of the car stereo to the
Pioneer amplifier. Normally, set the gain controls to the NORMAL position. If the output is
low, even when the volume of the car stereo is turned up, tum these controls clockwise. If
there is distortion when the volume of the car stereo is turned up, tum these controls
counter-clockwise.
• If you only use one input plug, set the gain controls for speaker outputs A and B to the same posi-
tion.
• When using with an RCA equipped car stereo (standard output of 500 mY), set to the NORMAL
position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more,
adjust level to match the car stereo output level.
•