Pioneer SA-1040 사용 설명서 - 페이지 2

{카테고리_이름} Pioneer SA-1040에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SA-1040 13 페이지.
Pioneer SA-1040에 대해서도 마찬가지입니다: 서비스 매뉴얼 (22 페이지)

페이지 인쇄

READ

INSTRUCTIONS

—

All

the

safety

and

operating

instructions

should

be read before

the

appliance is operated.

RETAIN

INSTRUCTIONS

— The operating instruc-

tions should be retained for future reference.

HEED

WARNING

—

All warnings

on the appliance

and in the operating instructions should be adhered

to.

INSTRUCTIONS

— All operating and use

instructions should be followed.

WATER

AND

MOISTURE

—

The appliance

should

not be used

near water

—

for example,

near

bathtub, washbowl, kitchen sink, laundry tub, ina

wet basement,

or near

a swimming

pool, etc.

LOCATION

—

The appliance should be installed in a

stable location.

WALL

CEILING

MOUNTING

—

The

appliance

should not be mounted to a wall or ceiling.

VENTILATION

— The appliance should be situated so

that its location or position does not interfere with

its proper ventilation.

For example,

the appliance

should

not

be situated

a bed,

sofa,

rug,

similar surface that may block the ventilation open-

ings; or, placed in a built-in installation, such as a

bookcase or cabinet that may impede the flow of

air through the ventilation openings.

HEAT

—

The appliance should be situated away from

heat

sources

such

radiators,

heat

registers,

stoves,

or other appliances

(including

amplifiers)

that produce heat.

POWER

SOURCES

—

The appliance should

be con-

nected to a power supply only of the type describ-

ed in the operating instructions or as marked on the

appliance.

POWER-CORD

PROTECTION

—

Power-supply cords

should be routed so that they are not likely to be

walked

or pinched

by items

placed

upon

against them, paying particular attention to cords

at plugs,

convenience

receptacles,

and the point

where they exit from the appliance.

The

lightning

flash

with

arrowhead,

within an equilateral triangle, is intended

to alert

the

user

of the

presence

uninsulated

''dangerous voltage' within

IMPORTANT

[FOR KU MODEL]

SAFETY

INSTRUCTIONS

[FOR KU MODEL]

CLEANING

—

The appliance should be cleaned

only

with a polishing

cloth or a soft dry cloth.

Never

clean with furniture wax,

benzine,

insecticides or

other volatile liquids since they may

corrode

the

cabinet.

POWER

LINES

—

outdoor

antenna

should

located away from power lines.

NONUSE

PERIODS

—

The

power

cord

of the ap-

pliance should be unplugged from the outlet when

left unused for a long period of time.

OBJECT

AND

LIQUID

ENTRY

—

Care should be

taken so that objects do not fall and liquids are not

spilled into the enclosure through openings.

DAMAGE

REQUIRING

SERVICE

— The appliance

should

be serviced by Pioneer authorized

service

center or qualified service personnel when:

The

power-supply

cord

the

plug

has

been

damaged; or

Objects have fallen, or liquid has been spilled into

the appliance; or

The appliance has been exposed to rain; or

The appliance does not appear to operate normally

or exhibits

a marked change in performance;

The appliance has been dropped; or the enclosure

damaged.

SERVICING

— The user should not attempt to service

the

appliance

beyond

that

described

the

operating instructions. For all other servicing, con-

tact the nearest Pioneer authorized service center.

OUTDOOR ANTENNA GROUNDING

— If an outside

antenna

is connected

to the antenna

terminal, be

sure the antenna system is grounded so as to pro-

vide some

protection

against voltage surges and

built up static charges.

In the U.S.A. section 810 of the National Electrical

Code, ANSI/NEPA

No. 70-1981, provides informa-

tion with respect to proper groundig of the mast

and supporting structure, grounding of the lead-in

wire to an antenna discharge unit, size of groun-

ding

conductors,

location

of antenna-discharge

unit, connection

to grounding electrodes,

and re-

quirements for the grounding

electrode.

See Fig.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK, DG

NOT REMOVE COVER (OR BACK). NO USER-

SERVICEABLE PARTS INSIDE. REFER SERVICING

EXAMPLE OF ANTENNA GROUNDING AS

PER NATIONAL ELECTRICAL CODE INSTRUC-

TIONS

Ground

clamp

a), b)

Mast

ground

wire

To Antenna terminal

—

Ground

wire

Ground

clamps

Grounding electrode

driven 8' into the earth

(2.44 meters)

Fig. A

Use No. 10 AWG (5.3 mm?) copper or No. 8 AWG

(8.4 mm?) aluminum or No. 17 AWG

(1.0 mm?)

copper-clad

steel

bronze

wire,

larger as

ground wires for both mast and lead-in.

Secure

lead-in

wire

from

antenna

* discharge unit and mast ground wire to house with

stand-off

insulators,

spaced from 4 feet (1.22

meters) to 6 feet (1.83 meters) apart.

Mount antenna discharge unit as closely as possi-

ble to where lead-in enters house.

exclamation

point

within

equilateral triangle is intended to alert the

the

presence

important

operating and maintenance (servicing) in-

structions in the literature accompanying

the appliance.

TO QUALIFIED SERVICE PERSONNEL.

the product's enclosure that may be of

sufficient magnitude to constitute a risk

of electric shock to persons.

IMPORTANT

To prevent electric shock, do not remove

cover.

No user ser-

viceable parts inside, refer servicing to qualified service personnel.

Always disconnect all the equipment from the mains supply when

disconnecting the signal leads. The power cord should be con-

nected last, make sure that the power switch is off.

Unplug the set from the wall socket when it is not to be used for an

extended period of time.

FOR USE IN UNITED KINGDOM

AND AUSTRALIA

CAUTION 240 V:

FOR USE IN UNITED KINGDOM

The wires in this mains lead are coloured in accordance with the

following cord:

Blue:

Neutral

Brown:

Live

As the colours of the wires in the mains lead of this apparatus may

not correspond

with the coloured

marking

identifying the ter-

minals in your plug proceed as follows:

The wire which is coloured biue must be connected to the terminal

which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the ter-

minal which is marked with the letter L or coloured red.

Equipment

sold in the U.K. is not supplied with a power

plug.

Mains supply voltage is factory

adjusted at 240 V.