Pioneer SA-1490 SD 사용 설명서 - 페이지 10

{카테고리_이름} Pioneer SA-1490 SD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SA-1490 SD 20 페이지.

페이지 인쇄

OPERATIONS

RECORDING TAPES:

e The sound compensated with the built-in graphic equaliz-

*®

While listening to playback on equipment connected to the

er can be recorded. Set the EQUALIZER ON/OFF switch to

rear panel terminals , you can record these same sounds on

The ON Pe Huon:

;

tape merely by setting your tape deck to the recording

Refer to the operating instructions for your tape deck for

mode.

proper operating procedures.

PLAYBACK

RECORDING

TO USE THE COMPONENT CONNECTED TO

(2) Remove the two connecting bars from the

THE ADAPTOR TERMINALS:

adaptor terminals.

Connecting the dynamic expander to the adapter makes it

possible to enjoy the dynamic expander's effects. Also, sur-

round sound can be enjoyed by connecting a surround pro-

cessing amplifier.

acta lie

Connecting

bars

(3) Connect the adaptor component in accor-

dance with the connection diagram in the

section ''Connections."

[Operation]

(1) Playback the source.

(2) Operate the adaptor component.

The sound compensated with the connected adaptor

component can be recorded on a tape deck. Signals

[Connection]

modified with an adaptor component can be recorded

(1) Set the POWER switch to OFF.

on a tape deck. However, surround sound from a sur-

round processing amp cannot be recorded.

NOTE:

Be sure to perform this operation with the adaptor component power

Switch in the ON position. Even when not using the adaptor corrpo-

nent, its power switch must be left ON. If the adaptor componert is

switched OFF, no sound will be produced, or the playback sound will

be distorted.

For details, refer to the adaptor component's operating insiruc-

tions.