Pioneer SA-1490 SD 사용 설명서 - 페이지 16

{카테고리_이름} Pioneer SA-1490 SD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SA-1490 SD 20 페이지.

페이지 인쇄

NAMES AND USES OF PARTS

TUNER

@ FM MONO switch/indicator

Normally

this is set to the off position

(the FM

MONO

indicator goes off). When noise spoils the reception of an FM

program, press the switch to the on position (the FM MONO

indicator will now light).

The program of an FM stereo broadcast will be heard in mono.

The setting of the FM MONO switch (on or off) is memorized

along with

the

station

frequency

in the

STATION

CALL

switches.

When using the preset tuning feature, reception will be in the

mode selected when the station was memorized.

This switch will not function for AM reception.

@ AUTO/MANUAL tuning switch/indicator

Use to select either the AUTO

mode or MANUAL

mode

for

FM/AM reception. (When the auto tuning mode is selected, the

AUTO TUNING indicator will now light.)

These are used to recall preset broadcasting

stations and to

preset the station.

@ MEMORY switch

This switch is used to memorize stations. When the switch is

Pressed, the frequency indicator will flash. To memorize the

frequency

of any station, press the STATION

CALL

switch

while the frequency display is flashing.

@ FREQUENCY

display

Permits reading of the received frequency at a glance from

the displayed figure. The FM band is indicated by MHz, and

the AM band by kHz.

@ TUNING switch

This is used to locate the stations.

Push either side of this switch; the left side "—" to go toa

lower, and the right side '+" to go to a higher frequency.

@ STEREO indicator

This lights when a stereo program has been picked up during

an FM broadcast.

This lights to indicate when the finest tuning of a station has

been achieved.