Ariston AVXL 129 사용 설명서 지침 - 페이지 3

{카테고리_이름} Ariston AVXL 129에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston AVXL 129 8 페이지.
Ariston AVXL 129에 대해서도 마찬가지입니다: 사용 설명서 지침 (13 페이지)

Ariston AVXL 129 사용 설명서 지침
If this is not the case, replace the socket or the plug. outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it
Dimensions Capacity Electric connections Water connections Spin speed Control programmes according to AS/NZS 2040.2 Care maximum pressure 1 MPa
(10 bar) minimum pressure 0.05 MPa (0.5 bar) drum capacity 52 litres up to 1200 rpm Troubleshooting programme 3; temperature 40°C; run with a load of
7,5 kg. This appliance is compliant with the following European Community Directives: - 73/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments
- 89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments The washing machine should not be installed in an Service 3
Washing machine description GB Control panel Leds Programme key Buttons FUNCTION START/STOP Button ON-OFF/DOOR LOCK l Led Detergent
dispenser Button PROGRAMME Knob START/RESET SPIN SPEED Knob TEMPERATURE Knob Detergent dispenser: to add detergent and fabric softener
Programme key to consult a straightforward chart of the different programmes available: pull the grey tab outwards to open it. LEDS: to find out which wash
cycle phase is under way. If the Delay Timer function has been set, the time left until the programme starts will be indicated (see page 5). SPIN SPEED knob:
to set the spin speed or exclude the spin cycle completely (see page 7). FUNCTION buttons: to select the functions available. The button corresponding to the
function selected will remain on. TEMPERATURE knob: to set the temperature or the cold wash cycle (see page 7). START/STOP button: to turn the washing
machine on and off. START/RESET button: to start the programmes or cancel any incorrect settings. ON-OFF/DOOR LOCK Led: to find out whether the
PROGRAMME knob: to select the wash programmes. The retractable control knob: press the centre of the knob for it to pop out. The knob stays still during
the cycle. 4 Leds The LEDS provide important information. This is what they can tell you: Delay set: If the Delay Timer function has been enabled (see page.
7), once you have started the programme, the LED corresponding to the delay set will begin to flash: Cycle phase under way: During the wash cycle, the
LEDs gradually illuminate on to indicate the cycle phase under way: Prewash Wash Rinse Spin cycle Note: during draining, the LED corresponding to the
Spin cycle phase will be turned on. Function buttons The FUNCTION BUTTONS also act like LEDS. When a function is selected, the corresponding button is
illuminated. If the function selected is incompatible with the programme set, the button will flash and the function will not be enabled. If you set a function
that is incompatible with another function you selected previously, only the last one selected will be enabled.
GB Installation Description Programmes As time passes, the remaining delay will be displayed, and the corresponding LED will flash: Detergents Once the
set delay is complete, the flashing LED will turn off and the programme set will start. Precautions Care Troubleshooting ON-OFF/DOOR LOCK led: If this
LED is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any damages, wait for the LED to flash before you open the
appliance door. The rapid flashing of the ON-OFF/DOOR LOCK Led together with the flashing of at least one other LED indicates there is an abnormality
(see page 11, Troubleshooting). Service 5 Starting and Programmes GB Briefly: starting a programme 1. Switch the washing machine on by pressing button .
All the LEDS will light up for a few seconds and the ON-OFF/DOOR LOCK Led will begin to flash. 2. Load your laundry into the washing machine and shut
4. Set the wash temperature (see page 7). Programme table Type of fabric and degree of Programmes soil Wash temperat.
exposed to rain and thunderstorms.
washing machine is on and if the appliance door can be opened (see page 5).
the appliance door. 3. Set the PROGRAMME knob to the programme required.
You're reading an excerpt. Click here to read official HOTPOINT
AVXL 129 user guide
http://somemanuals.com/dref/4691435
(see page 8).