Pioneer VSA-1000 사용 설명서 - 페이지 20

{카테고리_이름} Pioneer VSA-1000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSA-1000 35 페이지. Av digital surround amplifier
Pioneer VSA-1000에 대해서도 마찬가지입니다: 사용 설명서 (35 페이지)

페이지 인쇄

REMOTE CONTROL OPERATION

BATTERIES

1. Open the battery compartment cover on the rear of the remote

control unit. The cover should open easily if you slide it in the

direction of the arrow while pressing on it with your thumb.

2. Take out the four supplied alkali (LRO3/AM-4) batteries, and insert

them

into the battery

compartment

in accordance

with the

indications in the compartment.

3. Close the cover of the battery compartment.

Cover

Reset button

Incorrect use of batteries may lead to leakage or rupture.

Always be sure to follow these guidelines:

Always insert batteries into the battery compartment correctly matching

the positive

and negative

—

polarities, as indicated inside the

compartment.

Never mix new and used batteries.

Cc.

Batteries of the same size may have different voltages, depending on

their type. Do not mix different type of batteries.

RANGE OF REMOTE CONTROL

When operating the remote control unit, point the front of the unit at

the front panel of the VSA-1000. The remote control unit may be used

within a range of about 7 meters (23 feet) from the remote sensor,

within angles of up to about 30 degrees.

Battery Replacement

When the batteries have run out, the transmit indicator will not illuminate

even when a key is pressed. Be sure to replace the batteries as soon

as possible. As the programmed functions will be retained in memory

only as long as batteries are inserted, remove the old batteries only if

they can be replaced by new ones immediately.

Also, be sure to always use the specified batteries (LRO3/AM-4 alkaline

batteries).

NOTE:

When no batteries are inserted, the programmed memory contents will

be erased after approx.

15 minutes.