Pioneer VSA-E03 사용 설명서 - 페이지 30
{카테고리_이름} Pioneer VSA-E03에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSA-E03 48 페이지. Audio/video multichannel amplifier
페이지 인쇄Sound Modes
Selecting a Sound Mode
To ensure the best possible surround sound, be sure to complete the set up procedures described in "Setting Up for
Surround Sound" (starting on page 14) before using the sound modes. This is particularly important when using the
(Dolby) Surround mode. When using the sound modes, SPEAKERS A are used. If SPEAKERS B are selected and a
sound mode is turned on, selection automatically switches to SPEAKERS A only.
Surrround operation
TV
AMP
FQ
+
ENTER
–
FQ
VOL
VOL
CHANNEL
MULTI CONTROL
CD
DVD/LD
TV/SAT
VCR 1
TUNER
TV CONTROL
VCR 2
AMP
MD/TAPE
DSP MODE
MIDNIGHT
2
1
2
3
4
CH.SELECT
TEST TONE
ATT SIG.SELECT
6
5
7
8
CH.LEVEL
EFFECT
9
0
+10
MEMU
CLASS
TV/VCR
FUNCTION
DIRECT
FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
30
En
1
Press AMP.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the amplifier.)
2
Press DSP MODE to select the sound mode.
Each press changes the DSP mode as follows:
=HALL 1 = HALL 2 = JAZZ = DANCE
1
SFC OFF+ THEATER 2 + THEATER 1 +
memo
EFFECT –/+
• The amount of effect of each DSP mode can be adjusted in the range of 10
to 90 (the default setting value is 70) by pressing EFFECT –/+.