Pioneer VSP-200 사용 설명서 - 페이지 8
{카테고리_이름} Pioneer VSP-200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer VSP-200 15 페이지. Av surround processor/amplifier
페이지 인쇄
FRONT PANEL FACILITIES
—~
@
QD PIONEER
2 pmcnc mons mnnee
VECO
@ POWER STANDBY/ON switch/STANDBY indicator
This is the switch for electric power.
ON:
When set to the ON position, power is
supplied and the unit becomes operational.
When set to STANDBY position, the main
power flow is cut and the unit is no longer
fully operational.A minute flow of power
feeds the unit to maintain operation
readiness.
The
STANDBY
indicator
light when
the
power
is
STANDBY,and goes out during ON.
[Timer ON/OFF possible]
When the unit is switched ON, ON/OFF control can be
performed by means of the optional timer
NOTE:
When the power is intially turned ON, muting will be applied
to prevent sound from being output for about 6 seconds.
STANDBY:
@ INPUT SELECTOR buttons
Each time these buttons are pressed, the function changes
in the following sequence:
Ch ceca "|
VCR
VIDEO:
@ SURROUND MODE button
Each time this button is pressed,the surround mode
changes in the following sequence:
off —-» DOLBY PRO LOGIC
STUDIO SIMULATED SURROUND
8
<ARBIABS>
@
MASTER
VOLUME control
After adjusting the volume level on the amplifier you are
using,adjust volume to the same
level with this MASTER
VOLUME control.
® DOLBY 3CH LOGIC button
Use it to change DOLBY 3CH LOGIC to ON/OFF position.
© CENTER MODE indicators
(NORMAL, WIDE,PHANTOM)
Lights up when a center mode is selected with the CENTER
MODE button of the remote control unit.
@ Display section
SURROUND
MODE indicators
(DOLBY PRO LOGIC, SIMULATED, STUDIO)
Lights up when a surround mode is selected with the SUR-
ROUND MODE button.