Pioneer CMX-5000 사용 설명서 - 페이지 4

{카테고리_이름} Pioneer CMX-5000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer CMX-5000 20 페이지.

페이지 인쇄

1. Connections

Read before use

CAUTIONS REGARDING HANDLING

Location

Install the player in a well-ventilated location where it will not be

exposed to high temperatures or humidity.

Do not install the player in a location which is exposed to direct

sunlight, or near stoves or radiators. Excessive heat can

adversely affect the cabinet and internal components.

Installation of the player in a damp or dusty environment may

aiso result in a malfunction and can be hazardous. Avoid

installation near cookers etc., where the player may be exposed

to oily smoke, steam or heat.

Installation guidelines

÷ Placing and using the compact disc player for long periods on

heat-generating sources such as amplifiers or near

spotlights, etc. will affect product performance. Avoid placing

the player on heat-generating sources.

÷ Install this compact disc player as far as possible away from

tuners and TV sets. A compact disc player installed in close

proximity to such equipment may cause noise or degradation

of the picture.

÷ Noise may be noticeable when an indoor antenna is used. In

such cases, make use of an outdoor antenna or turn off

power to the compact disc player.

÷ When the unit is used in a loud-sound environment, e.g., near

a speaker, sound skip may occur. Install the unit away from

the speaker or reduce the listening volume.

÷ Place this unit on a level surface and a stable platform.

÷ Be sure the player, including its audio and power supply

cords, does not touch vibrating materials. Any cause of

vibration other than the insulators may cause the disc to skip.

Take special care when using the player while it is installed in

a carrying case.

Do not place on or against

vibrating materials!

Installing the CMX-5000 in an EIA rack

The screw holes on the front panel o the CMX-5000 are

designed for use in attaching the unit to a 19-inch EIA rack.

÷ Remove the four legs on the unit before installing the unit in

the rack.

÷ Use four 3/16-inch-diameter, 3/8-inch-length screws to attach

to rack. (Screws not included with CMX-5000 CD player.)

Note

÷ Never place this CD player directly above a power amplifier,

as the heat given off by the amplifier might result in damage

to the unit. Placing the CD player directly above a power

amplifier might also result in ham radio signals being picked

up or in other types of interference.

÷ Always be sure to remove the CD player from its rack before

shipping.

÷ When moving the CD player while still installed in its rack,

exercise caution to avoid subjecting the player to shocks or

vibration.

Cleaning the player

To clean the PLAYER wipe with a polishing or a soft, dry cloth.

For stubborn dirt, moisten a soft cloth with a weak solution of

neutral detergent (diluted in five to six parts water), wring the

cloth well, and wipe away the dirt. Use a dry cloth to wipe the

surface dry. Do not use volatile liquids such as benzene or

thinner which will damage to the unit.

CD lens cleaner

The player's pickup lens should not become dirty in normal use.

If for some reason, the lens becomes soiled and malfunctions,

contact your nearest PIONEER authorized service center. Lens

cleaners for CD players are commercially available, but special

care should be exercised in their use as some may cause

damage to the lens.

Storing discs

÷ Discs are made of the same kinds of plastic used for

conventional analog audio records. Be careful not to allow

discs to warp. Always store discs in their cases vertically,

avoiding locations with high heat, humidity, or extremely low

temperatures. Avoid leaving discs in cars; the interior of a car

in direct sunlight can become extremely hot.

÷ Always read and abide by the precautionary notes listed on

disc labels.

Condensation

When this unit is brought into a warm room from previously cold

surroundings or when the room temperature rises sharply,

condensation may form inside the unit and impair its

performance. In such cases, allow the unit to stand for about an

hour or raise the room temperature gradually.