Pioneer Elite PD-D6MK2-K Elite D6 사용 설명서 - 페이지 19
{카테고리_이름} Pioneer Elite PD-D6MK2-K
Elite D6에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite PD-D6MK2-K
Elite D6 40 페이지. Super audio cd player
Pioneer Elite PD-D6MK2-K
Elite D6에 대해서도 마찬가지입니다: 사양 (2 페이지)
페이지 인쇄
Additional information
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Inspect the other components and electrical appliances being used. If the
trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized
service center or your dealer to carry out repair work.
Problem
The disc won't play or is
automatically ejected
after loading.
The remote control
doesn't seem to work.
No audio, or audio is
distorted.
The analog audio is OK,
but there appears to be
no digital audio signal.
Noticeable difference in
SACD and CD volume.
Cannot play
multichannel audio.
Settings are erased.
Note
• Static electricity or other external influences may cause malfunctioning of this unit. In this
case, unplug the power cord and then plug back in. This will usually reset the unit for proper
operation. If this does not correct the problem, please consult your nearest Pioneer service
center.
Remedy
• Make sure the disc is free from dirt and dust and is not damaged (page 17).
• Check Disc/content format playback compatibility on page 8 to confirm that the
disc is compatible with this player.
• Make sure the disc is loaded with the label side face-up and aligned properly
in the disc tray guide.
• Condensation inside the player: Allow time for condensation to evaporate.
Avoid using the player near an air-conditioning unit.
• The remote control is too far from the player, or the angle with the remote
sensor is too wide: Use the remote within its operating range (page 12).
• If you're trying to switch on using the remote control, make sure the front
panel POWER button is switched on first.
• The battery is exhausted: Replace the battery (page 7).
• Check that the disc is not damaged, and free from dust and dirt (page 17).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and clean if
necessary. Also check the cable for damage.
• Make sure the player's output is not connected to the amplifier's phono
(turntable) inputs.
• Check your amplifier/receiver's settings (volume, input function, speaker
settings, etc.).
• Make sure that Pure Audio feature is switched off (page 16).
• SACDs do not output digital audio. The signal is heard through the player's
analog audio outputs.
• This is due to differences in the audio format and is not a malfunction.
• This player is not compatible with multichannel audio.
• If you have switched the unit off (using the front panel POWER button) for
more than 30 days, all settings will be erased.
06
19
En