Pioneer PR-8210 사용 설명서 - 페이지 24

{카테고리_이름} Pioneer PR-8210에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PR-8210 26 페이지. Videodisc player
Pioneer PR-8210에 대해서도 마찬가지입니다: 사용 설명서 (26 페이지), 추가 서비스 매뉴얼 (6 페이지)

Pioneer PR-8210 사용 설명서
TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
e
Power cord is not properly plugged into AC
wall socket.
e
Power switch is not turned on.
e
Turn on power switch.
è
Press REJECT/OPEN key,
e
Latch is not released.
e
Power is not on.
e
Plug in power cord.
Disc does not rotate.
e
Hood is not shut completely
e Turn on power switch.
e
Push hood and close it firmly so latch locks.
Disc stops rotating
e
You are playing the unrecorded side of a disc. | e Turn over disc.
soon after starting.
Disc rotates but
e
TV is not turned on.
e
Turnon TV.
there is no picture.
e
Make correct connections.
e
Set TV to the channel (3 or 4) that is not used
for TV broadcasting in your area.
e
Wrong connection from player to TV.
e
TV set is not tuned to channel 3 or 4.
e Player VHF CHANNEL SELECTOR is at the
wrong setting.
e
Player is in the PAUSE mode.
e
Set to same channel.
e
Press the PLAY key.
e
Check all connections, particularly F type
plugs.
e
Both TV and player must be set to the same
channel (3 or 4) which is not used for TV
broadcasting in your area,
Picture quality is bad.
| e
Bad connections between player and TV set.
e
Player VHF out channel is different from TV
channel.
e
Adjust TV fine tuning knob for optimum pic-
ture quality.
e
TV fine tuning has not been adjusted.
e
Try playing a different disc. If other discs give
good quality, the problem is with that partic-
ular disc.
e
Poor disc.
e
Connect VHF antenna cable to ANTENNA
IN terminal on the player.
TV no longer receives
| *
Antenna cable has not been connected.
other channels after
it has been connected
to the player.
e
To view regular TV broadcasts, remember to
turn off the power on the player.
e
Power on the player is being turned on.
e
Press the SCAN key to skip over damaged
portion.
A particular part of
e
Damaged disc.
a paticular disc is
not reproduced
properly.
Remote control
e
Remote control unit batteries are weak.
e
Replace batteries.
does not work.
e
Remove the obstacle or shift the remote
control.
e
Anobstacle between the player and the
remote control unit.
e
Locate the remote control unit in front of the
player.
e
Remote control unit is not located in a good
direction for transmission.
18