Pioneer X-CM56D 사용 설명서 - 페이지 18

{카테고리_이름} Pioneer X-CM56D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer X-CM56D 38 페이지. Cd receiver system

페이지 인쇄

Disc playback

Chapter 5:

Disc playback

This system can play back a standard CD, CD-R/RW in the

CD format and CD-R/RW with MP3 files, but cannot record

on them. Some audio CD-R and CD-RW discs may not be

playable due to the state of the disc or the device that was

used for recording.

• For details about MP3, see page 35.

Playing discs or files

Load the disc

Press Í to turn the power on.

Press CD on the remote control or INPUT

repeatedly on the main unit to select CD input.

Press < on the main unit to open the disc tray.

Place the disc on the disc tray, label side up.

Press < on the main unit to close the disc

tray.

Play tracks on a CD

When the recognition is completed, press

1; .

After the last track is played, the unit will stop automatically.

Play MP3 music files

MP3 track data is called "music file" and the location they are

stored is called a "folder" in this document.

e.g.,

When the recognition is completed, press

/ to select the folder where the music file is

stored ([ ]), then press

• Repeat this step if there are other folders inside the

selected folder.

• To return to the previous folder, press

Press /

to select the music file ([ ]), and

then press 1; or ENTER.

• Once play starts, only music files inside the same folder

can be played continuously.

CAUTION

• Do not place two discs in one disc tray.

• Do not play discs of special shapes (heart, octagon,

etc). It may cause malfunctions.

• Do not push the disc tray whilst it is moving.

• If the power fails whilst the tray is open, wait until the

power is restored.

• Be sure to place 8 cm disc in the middle of the disc tray.

Note

• Due to the structure of the disc information, it takes

longer to read an MP3 disc than a normal CD

(approximately 20 to 90 seconds).

• When the beginning of the first track is reached during

fast reverse, the unit will enter the playback mode (only

for CD).

• If TV or radio interference occurs during CD operation,

move the unit away from the TV or radio.

Tip

• When no operation has done in CD mode and the audio

file is not played for more than 20 minutes, the power

will automatically turn off. In this case it is required that

the Auto power off is switched to ON.

• Auto power off can be switched to ON/OFF (page 36).

or ENTER.

