Pioneer DV-393-S 사용 설명서 - 페이지 13

{카테고리_이름} Pioneer DV-393-S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DV-393-S 48 페이지. Pioneer operating instruction dvd player dv-393-s dv-490v-s
Pioneer DV-393-S에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지), 사용 설명서 (48 페이지), 사용 설명서 (48 페이지)

페이지 인쇄

Connecting up

Connecting using the

component video output

You can use the component video output

instead of the standard video out jack to

connect this player to your TV (or other

equipment). This should give you the best

quality picture from the three types of video

output available.

•

Use a component video cable (not

supplied) to connect the COMPONENT

VIDEO OUT jacks to a component video

input on your TV, monitor or AV receiver.

HDMI

OUT

COAXIAL

DIGITAL AUDIO OUT

COMPONENT VIDEO OUT

Watching progressive scan video

from the component video outputs

This player can output progressive scan video

from the component video output. Compared

to interlace video, progressive scan video

effectively doubles the scanning rate of the

picture, resulting in a very stable, flicker-free

image.

To set up the player for use with a progressive

scan TV, see Video Output settings on page 35.

When the player is set to output progressive

scan video, the PRGSVE indicator lights in the

front panel display.

COMPONENT

VIDEO IN

VIDEO OUT

AUDIO OUT

Important

• When Component Out (page 35) is set to

Progressive, there is no video output from

the VIDEO OUT (composite) jack.

• If you want to display video on more than

one monitor simultaneously, make sure

the player is set to Interlace.

• If you connect a TV that is not compatible

with a progressive scan signal and switch

the player to progressive, you will not be

able to see any picture at all. In this case,

switch everything off and reconnect using

the supplied video cable (see Easy

connections on page 11), then switch back

to Interlace (see below).

Switching the video output to interlace

using the front panel controls

Switch the player to standby then, using the

front panel controls, press

while pressing

to switch the player back to

Interlace.

• DV-490V only: If the player is connected

using HDMI, disconnect the HDMI cable

before resetting the player to interlace

output. (If left connected, the HDMI output

resolution will be reset to its default—see

Resetting the output resolution to the

default setting with HDMI connection on

page 15.)

STANDBY/ON

DV-490V

STANDBY/ON