Pioneer S-HTD510 사용 설명서 - 페이지 17
{카테고리_이름} Pioneer S-HTD510에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-HTD510 48 페이지. Dvd receiver/speaker system
Pioneer S-HTD510에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)
4
S
Press I_ to move on to the CENTER
speaker
se_ing.
Use the • and • buttons to set the
distance from your main listening posi-
tion to the center speaker.
The default setting is 3m. Youcan adjust the range
froln 0.3m to 9.0m in steps of 03m.
6
7
Press I_ to move on to the SURROUND
speakers setting.
Use the • and • buttons to set the
distance from your main listening posi-
tion to the surround speakers.
Ideally,your listening position should be equidistant
from the surround speakers.
The default setting is 3m. Youcan adjust the range
froin 0.3m
to
9.0m in steps of 03m.
8
Press ENTER to exit.
• The setting mode is automatically exited if no
operation is perfommdwithin 20 seconds,
• Them are several other settingsthat you cm_make
from the SystemSetupmenu m further tailor your
surround sound. Seechapter 9 for nmre on this,
• The speakerdistance settingshave no effectwhen the
surround mode is set to VIR.SURR.1or VIR.SURR.2,
Seepage 23 for more on surround modes,
_'_
Note
_u can't m_e these settings with _e Reco_ modeon.
Seepage 25 for how to switchthe Recordmode 011J01_,
Balancing
the surround
sound
Youca_ further improve sun'ound sound performance
by balancing the levelsfi'om the subwooM;center and
surround speakers relative to the front left!right
speakers.% help you judge the sound levelofeach
speakera testtone is playad through each speaker in
turn (make sum that them are no hemtphones
connected).Adjust the levelsuntil they all sound equal.
the levelsyou set hem will apply to all sun'ound modes.
lIowevel; y ou cm_set levelsindependentlyfbr each DSP
mode.
2
3
4
S
]
Note
It may not be possibleto accurately adjust the
subwooferlevelusing this method. Youmay preferto
leave it on its default setting mid adjust it to your liking
later when playing sun'ound-sound sources.
• You cannot change the DSPmode when Record
mode is active (seeDirect recordi*zgon page 25).
Press SURROUND
MODE.
The sun'ound nmde can be set to anything exc@t
SURROUND OFF or AUTO (No test toim is
output
in
these nmdes.)
Set the volume
to a moderate
level.
Press TEST TONE
(SHIFT
& CH
LEVEL) to
start the
test tone then
adjust
the
volume
to a suitable level.
The testtone playsthrough each speaker in turn:
• Fmnt left
• Center
• Front right
• Surround right
• Surmund left
• Subwoofer
Use the • and • buttons to adjust the
level of
a
speaker as the test tone plays.
For bestresults, sit in your main listening
position
when
doing this. You can adjust each speaker in the rmlge of
+/-10dB.
When you're
done,
press TEST TONE
(SHIFT & CH LEVEL) to turn
off the test
tone.