Pioneer S-HTD510 사용 설명서 - 페이지 34
{카테고리_이름} Pioneer S-HTD510에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-HTD510 48 페이지. Dvd receiver/speaker system
Pioneer S-HTD510에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)
페이지 인쇄Dual-mono
setting
The dual-mono setting applies only to DolbyDigital
discs that fealum dual-mono material--see the disc
box for details.
Dual-mono discs are recordedwith two independent
charnels that may be played together or separately
depending on the situation. Forexmnple, a guita'
tuition discmight have lhe guita' recordedo,1one
channel and all the other insh'uments on the othe*:Use
the dual-mono setting to play just the guitar part on its
own; just the backing, or eveuthiug logether (thmugh
separate speakers,or mixed).
•
Youcroft chalge this setting if the Recordmode is
on (seepage 25).
Press SYSTEM SETUP.
Press the 41 or I_ button until you see
CH or MIX in the display.
Use
the •
and
•
buttons to
select a dual-
mono
setting.
• L-CH1 R-CH2 - default setting (Chl is played
through the left speaker; Ch2 lhmugh the right)
• CH1 -Chlisplayedthmughtheceuterspeaker
(or lhmugh the left aid right speakers if Surround
Off is selected);Ch2 is muted.
• CH2 - Ch2 is played thmugh the center speaker
(or lhmugh the left aid right speakers if Surround
Off is selected);Chl is muted.
• MIX - Chl a_d Ch2 are mixed logether aid played
through the center speaker (or through both left m_d
right speakers if Surround
Off is selected).
Press ENTER.
Adjusting
channel volume levels
I_pending on your room aud where you're sitting, you
may wm_tto _Ijust the relative volumes of one or more
speakers for a more balanced sound. You cm_do this in
auy mode, including the surmund, DSP,aud stereo
modes. Settings that you make in auy sound mode are
completely independent and don't affectany other
mode.
2
r_
Note
•
Each DSPeffecthas its own set of chatmel level
setliugs.
•
The charnel levelsyou set for the Surround mode
apply toStanda'd aid all AdvancedTheater effects.
•
The headphone levelis not gfected by the charnel
levelsetliugs.
Press CH LEVEL.
Adjnslmeutsto the channel w)lume levelswill _fect
only the current sound mode.
Use the
41 and I_ buttons
to select a
channel to adjust.
Thedisplay shows thecharnel and itscurrentsetting
• Rememberthat not all channels are available in all
sound modes.
3
Use the • and • buttons to adjust the
volume of the current channel.
Forbestresults, s it in yourmain listeningpositionwhen
doing this Youcanaljust eachspeaker i n theraugeof
+/-lOdB.
4
When you're done, press ENTER.