Pioneer ]S-2EX 사용 설명서 - 페이지 4

{카테고리_이름} Pioneer ]S-2EX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer ]S-2EX 26 페이지. Pioneer speaker system operating instructions
Pioneer ]S-2EX에 대해서도 마찬가지입니다: 카탈로그 (20 페이지), 브로셔 및 사양 (16 페이지), 서비스 매뉴얼 (10 페이지)

페이지 인쇄

1. Specifications

• You can also use banana plugs for this connection. To do

so, you must first remove the caps from the terminal

posts.

Short bar connectors

Black terminal ( )

Connect the other ends of the cables to the amp's

speaker output terminals (for more details, refer to your

amp owner's manual).

• After connecting the plugs, pull lightly on the cables to

make sure that the ends of the cables are securely

connected to the terminals. Poor connections can

create noise and interruptions in the sound.

• If the cables' wires happen to be pushed out of the

terminals, allowing the wires to come into contact with

each other, it places an excessive additional load on the

amp. This may cause the amp to stop functioning, and

may even damage the amp.

• When using a set of speakers connected to an amplifier,

you won't be able to obtain the normal stereo effect if the

polarity ( , ) of one of the speakers (left or right) is

reversed.

Bi-wiring Connections

Bi-wiring requires two cables for each speaker, one for high

frequencies and one for low frequencies. Using separate

cables for the high end and low end improves the sound.

Speaker

Black Red

Loosen the cap knobs on the left input terminals and

remove the two short bars.

In this state, the low-frequency speakers and the higher-

frequency speakers are completely independent. Store the

short bars in a safe place for later use. The lower terminals

are for the bass, and the upper terminals are for midrange

and treble sounds.

Red terminal ( )

Speaker

Amplifier

Black Red

R ch L ch

Insert a speaker cable into each of the terminal post

holes, then tighten the knobs.

High frequency

terminals

Low frequency

terminals

Black terminal ( )

Caution: when bi-wiring

Note that in this setup, connecting the cables with the

polarity reversed may seriously degrade the tone; refer to the

section "Connecting the cables" again and confirm that the

cables are connected properly.

Connect the matched pairs to the same speaker

terminals on your amp (taking care not to get the

polarity reversed).

Make sure to use the same type of cable for the low-fre-

quency and the same type for the high-frequency connec-

tions.

When bi-amping

Bi-amping is an even more powerful way of connecting your

speakers. Just as with bi-wiring, the input terminal short bars

are removed, but here the low-frequency terminals are

connected to a separate, dedicated low-frequency amp, and

the high-frequency terminals are connected to a dedicated

high-frequency amp.

Tweeter amp

Speaker

R ch L ch

Black Red

Woofer amp

R ch L ch

Red terminal ( )

Speaker

Black Red