Pioneer ELITE S-LX 70-LR 사용 설명서 - 페이지 4

{카테고리_이름} Pioneer ELITE S-LX 70-LR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer ELITE S-LX 70-LR 15 페이지.

페이지 인쇄

Installing the speakers

This speaker system cannot be placed directly on the surface of

floors or shelves. Always attach to a wall using the supplied

brackets, or use speaker stand CP-LX70 (floor stand) (sold

separately) or CP-LX70TS (tabletop stand) (sold separately) when

placing on the surface of floors or shelves.

• This speaker system is magnetically shielded. However,

depending on the installation location, color distortion may

occur if the speaker system is installed extremely close to the

screen of a television set. If this happens, turn the power switch

of the television set OFF, and turn it ON after 15 to 30 minutes.

If the problem persists, place the speaker system away from the

television set.

Mounting on walls

• Make sure that the wall you intend to mount the speakers on

is strong enough to support them.

• Remember that the speaker system is heavy. Improper

installation of the speakers could cause them to fall and

cause damage or injuries to persons nearby.

• Mounting screws are not supplied. Use screws suitable for

the wall material and support the weight of the speaker.

If you are unsure of the qualities and strength of the walls,

consult a professional for advice.

Once decided on the location of installation (such as the wall space

to the left and right of the TV), attach the speakers following the next

procedures.

Two types of brackets (for speakers) are supplied. When using

alongside with a Pioneer plasma display, use the L-type brackets.

When attaching flush against the wall, use the S-type brackets.

The left and right wall brackets are shaped differently. Be sure to

install the correct bracket on each side.

Bracket (for wall/Left)

Bracket (for wall/Right)

Connect speaker cables.

• Speaker cables are not included with this speaker system.

This speaker does not include speaker cables used for connecting

to an amplifier. Take the following factors into consideration when

choosing speaker cables so that you can get the most from your

speaker system:

• Use heavy-gauge speaker cable if possible, and keep the cables

to the minimum necessary length.

• If the length of cable required for left and right speakers differs,

use cables of the same length, matched to the longer distance.

• Cables have differing characteristics. Keep this in mind when

using any cable.

• Connections at speaker and amplifier terminals should be

made as tight and secure as possible to help reduce contact

resistance.

When mounting the speakers onto walls using the brackets,

connect the speaker cables before attaching speakers onto the

brackets.

• If the cables' wires happen to be pushed out of the terminals,

allowing the wires to come into contact with each other, it

places an excessive additional load on the amp. This may cause

the amp to stop functioning, and may even damage the amp.

• After connecting the plugs, pull lightly on the cables to make

sure that the ends of the cables are securely connected to the

terminals. Poor connections can create noise and interruptions

in the sound.

• When using a set of speakers connected to an amplifier, you

won't be able to obtain the normal stereo effect if the polarity

(+ , –) of one of the speakers (left or right) is reversed.

Paste the supplied wall mounting template on the area of

installation.

• The left and right wall mounting templates are shaped

differently.

Attach the template level to the ground using an adhesive such as

tape. Make sure the template is straight to avoid mounting the

speaker crookedly. Pasting the template too close to the TV may

cause the TV to get in the way of the speaker when installing. Make

sure the template and TV do not overlap.

Template (Left)

Template (Right)