Pioneer HTP-GS1 사용 설명서 - 페이지 15

{카테고리_이름} Pioneer HTP-GS1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer HTP-GS1 35 페이지. 5.1ch surround system

페이지 인쇄

Controls and displays

Using the remote control

Please keep in mind the following when using the remote

control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit's

remote sensor.

• Remote controllers for different devices can interfere

with each other. Avoid using remotes for other

equipment located close to this unit.

• Replace the batteries when you notice a fall off in the

operating range of the remote.

• Use within the operating range in front of the remote

control sensor on the display unit, as shown.

Putting the batteries in the remote

control

Open the battery compartment cover on the back of

the remote control.

Insert two AA/LR6 alkaline batteries into the

battery compartment following the indications ( , )

inside the compartment.

Close the cover.

Caution

Incorrect use of batteries can result in hazards such

as leakage and bursting. Please observe the

following:

• Don't mix new and old batteries together.

• Don't use different kinds of battery together—

although they may look similar, different batteries

may have different voltages.

7 m

• Make sure that the plus and minus ends of each

battery match the indications in the battery

compartment.

• Remove batteries from equipment that isn't going to

be used for a month or more.

• When disposing of used batteries, please comply

with governmental regulations or environmental

public instruction's rules that apply in your country or

area.

WARNING

• Do not use or store batteries in direct sunlight or

other excessively hot place, such as inside a car or

near a heater. This can cause batteries to leak,

overheat, explode or catch fire. It can also reduce the

life or performance of batteries.