Pioneer HTP-GS1 사용 설명서 - 페이지 29
{카테고리_이름} Pioneer HTP-GS1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer HTP-GS1 35 페이지. 5.1ch surround system
페이지 인쇄
Additional information
Chapter 9
Additional information
Setting the sleep timer
The sleep timer switches off the receiver subwoofer after
a specified time so you can fall asleep without worrying
1
about it.
MCACC
7
SURROUND ADVANCED
1
Press the SLEEP button to select an option.
Choose between the following options:
• SLP ON – Switches off after about an hour
• SLP OFF – Cancels the sleep timer
After selecting SLP ON, you can press SLEEP again to
check how much time is left. Each line indicates
approximately 12 minutes (remaining):
S L P - - - - -
Dimming the display
AUDIO
SUBTITLE
SETUP
ENTER
MCACC
7
SURROUND ADVANCED
0
You can choose to dim the display if you find it too
2
bright.
1
Press SETUP .
2
Use the
(cursor left/right) buttons to select
DIMMER then press ENTER .
3
Use the
(cursor up/down) buttons to select
LIGHT or DARK then press ENTER .
Note
1 The display dims and the blue indicator on the display switches off when the sleep timer is set.
2 The display dims and the blue indicator on the display switches off when the sleep timer is set, regardless of this setting.
TIMER REC REC MODE
+
SR
ONE TOUCH COPY
3
MENU
TEST TONE
SLEEP
9
SOUND
TV/DVD
ANGLE
PLAY MODE
TIMER REC REC MODE
+
SR
ONE TOUCH COPY
3
MENU
TEST TONE
9
SOUND
TV/DVD
JUKE BOX
DTS CD setting
If you play a DTS-encoded CD, you will need to change
this setting to hear the decoded signal.
1
Switch the system into standby.
2
Press SETUP .
3
Use the
(cursor left/right) buttons to select
CD TYPE from the menu, then press ENTER .
4
Use the
(cursor up/down) buttons to select a
setting, then press ENTER .
Select from:
• NORMAL – Use for playback of regular audio CDs.
Some DTS-encoded CDs will output noise when
played.
• DTS-CD – Use for playback of DTS-encoded CDs, but
note that the beginning of regular CD tracks may be
skipped.
Resetting the system
Use this procedure to reset all system settings to the
factory default.
1
Switch the system on.
2
Press and hold SURROUND then press the
STANDBY/ON button on the display unit.
The next time you switch on, all the system settings
should be reset.
Installation and maintenance
Hints on installation
We want you to enjoy using this system for years to come,
so please bear in mind the following points when
choosing a location:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such as a table, shelf or
.
stereo rack
Don't...
Use in a place exposed to high temperatures or humidity,
including near radiators and other heat-generating
appliances.
Place on a window sill or other place where the system will
be exposed to direct sunlight.
09
29
En