Pioneer MLXTW 서비스 매뉴얼 - 페이지 21

{카테고리_이름} Pioneer MLXTW에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer MLXTW 36 페이지.

페이지 인쇄

8. PANEL FACILITIES

FRONT PANEL

1 Power Indicator (STANDBY/POWER ON)

When power is switched on, the power indicator lights green. If

no signal is present for more than 8 minutes, the subwoofer

automatically reverts to standby mode and the power indicator

lights red. If, subsequently, a signal is received, power

automatically comes back on and the power indicator lights

green.

* If you are not using the unit for an extended period of time, please

switch off using the power switch, and make sure that the power

indicator goes out.

2 Power switch (POWER)

When pressed, power is turned ON; when pressed again, power is

turned OFF.

STANDBY/

POWER ON

POWER

REAR PANEL

PHASE

TURNOVER

—

0˚

180˚

LINE LEVEL

INPUT

OUTPUT

1 Phase switch (PHASE — 0˚ / _ 180˚)

When depressed (_ 180˚), the output phase becomes the

reverse of the input signal, and when raised (— 0˚ ), it is in the

same phase as the input signal.

÷ Normally, the switch is set to (— 0˚ ).

But when the sound connection between the subwoofer and

the left and right speakers sounds unnatural, try switching to

180˚ and set the switch in the position where the sound is

natural.

2 Line Level Input terminal (LINE LEVEL INPUT)

Connects to the stereo amplifier's SUBWOOFER PRE-OUT

terminal, with the specially provided RCA plug cord.

3 Line Level Output terminal (LINE LEVEL OUTPUT)

Used for connecting other equipment through the amplifier.

4 Turnover knob (TURNOVER)

Sets the high limit of the frequency played back by the

subwoofer.

÷ Setting Criteria

50Hz ..................... when the diameter of the left/right speakers

is 20 cm or more.

100Hz ................... when the diameter of the left/right speakers

is 10 – 25 cm.

200Hz ................... when the diameter of the left/right speakers

is 12 cm or less.

5 Level knob (LEVEL)

Sets the subwoofer volume.

÷ Turn the knob slowly from the MIN position.

÷ With this unit, the bass level can be independently set, so do

not turn up the bass on the stereo amplifier.

6 Speaker Level Output terminals

(SPEAKER LEVEL OUTPUT)

When the speakers output terminals on the stereo amplifier are

connected to this unit's SPEAKER LEVEL INPUT terminals 7

and used as the unit's input signal, these terminals are used to

connect the left and right speakers via the unit.

7 Speaker Level Input terminals

(SPEAKER LEVEL INPUT)

Connect to the speakers output terminals on the stereo amplifier,

with the specially provided speaker cords.

S-W80S

LEVEL

200

MIN

MAX

OUTPUT

INPUT

SPEAKER LEVEL