Pioneer PDP-S33-LR XIN/UC 사용 설명서 - 페이지 4

{카테고리_이름} Pioneer PDP-S33-LR XIN/UC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PDP-S33-LR XIN/UC 20 페이지.
Pioneer PDP-S33-LR XIN/UC에 대해서도 마찬가지입니다: 서비스 매뉴얼 (9 페이지)

페이지 인쇄

English

CAUTION

When the display is to be moved after speaker

installation, do not hold the display by the speakers.

Do not hold the speakers and raise the display. This

may cause the deformation or damage of products.

CONNECTION TO A PLASMA

DISPLAY

1 Connecting the speaker cables

Before connecting the speaker cables, unplug the Plasma

Display from the power outlet. After you have finished

connecting up, plug the unit back into the power outlet.

Connect the input terminals of the speaker system and

the speaker output terminals of the Plasma Display with

the accessory speaker cables. Make sure the positive (ª)

and negative (·) terminals match when connecting.

1. Push the lever, insert the cable into the hole, and release

the lever.

· terminal (black) ª terminal (red)

White

To the· terminal

(Speaker input terminals of the speaker system)

2. For the output terminals on the Plasma Display, push the

lever, insert the cable into the hole, and release the lever.

ª · · ª

÷ After connection to the terminals, pull lightly on the cable

to confirm that the tips of the cable are properly con-

nected to the terminals. An imperfect connection can

cause sound interruptions and noise.

÷ When cable cores stick out and ª and · lines are short-

circuited, an excessive load will be applied to the Plasma

Display and the operation will stop or trouble will be

caused.

÷ When the polarity is reversed for one speaker (left or right)

at the time of connection to the Plasma Display, the bass

reproduction will be reduced, the sound positioning will

be lost, and a correct stereo effect will not be obtained.

÷ If you insert the speaker cable too far so that the insula-

tion is touching the speaker terminal, you may not get

any sound.

< right >

Input terminal of speaker

White with gray line

To the ª terminal

Output terminal of Plasma

Display

< wrong >