Pioneer PDP-S44-LR 사용 설명서 - 페이지 9
{카테고리_이름} Pioneer PDP-S44-LR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PDP-S44-LR 33 페이지. Operating instructions
Pioneer PDP-S44-LR에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지)
페이지 인쇄
Fit the hooks at the top of the speakers over the screws just
inserted, then align the holes in the hooks of the speakers
over the screw holes at the bottom of the Plasma Display
and use the M8 screws to screw loosely into place.
Screws (M8)
WARNING
Connecting the cords
Turn off the power of all connected units before connecting the cords.
Connect the display's SPEAKER R and L terminals with the
speakers' terminals using the included connection cords.
After connecting the speaker
terminals with the connection cords,
confirm that the cords are connected
at the terminal securely by tugging
on the cords. A loose connection may
cause sound dropouts or noise.
When the speakers are installed on the Plasma Display, do not move the unit by lifting up the
speakers. The Plasma Display could fall and cause injury.
Tighten the screws just inserted firmly into place
(4 locations).
*Tighten the screws while pushing the speakers lightly
against the Plasma Display. Check to be sure that all
four screws have been screwed firmly into place.
There is polarity
connection cord.
Connect each conductor to the correct terminal.
While holding the button of each speaker
t e r m i n a l , i n s e r t a c o n d u c t o r o f t h e
connection cord.
Cord Clamper
Remove the seal from the rear of the cord clampers,
attach the clampers in the desired position, and clamp the
cords into place.
E-3
with the conductor of each
Black
Red