Pioneer S-IW531L - In-Wall Left Center Right Pivoting Soft Dome Tweeter Speaker 사용 설명서 - 페이지 6
{카테고리_이름} Pioneer S-IW531L - In-Wall Left Center Right Pivoting Soft Dome Tweeter Speaker에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-IW531L - In-Wall Left Center Right Pivoting Soft Dome Tweeter Speaker 17 페이지. In-wall speaker
Pioneer S-IW531L - In-Wall Left Center Right Pivoting Soft Dome Tweeter Speaker에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 사양 (1 페이지)
페이지 인쇄
14 Adjust the setting of the treble control as
necessary.
• The standard setting is 0.
• The treble switch located in the front of the speaker
has three positions to choose from, +/0/–.
15 Attach the butyl rubber tapes on the inside of the
grille.
Attach the eight butyl rubber tapes
to each grille, lining up the butyl
rubber tapes to the marks on the
inside of the grille.
Then peel off the protective paper.
16 Attach the grille to the speaker.
The grille is designed with a specific mounting
orientation. Gently push the grille onto the speaker, lining
up the corners of the grille to the grooves in the speaker.
Then line up the entire grille to the grooves in the speaker
and attach the grille by pressing in on the edges.
Orientate the grille so that
the edge marked in blue is
located at the top of the
speaker.
• Once you have pushed it in, make sure you press it
firmly against the speaker so that the grille doesn't
fall off and cause an accident.
• To remove the grille, use the supplied tool to hook
into the holes located near the corners and pull the
grille out. When doing this, make sure to pull all four
corners out evenly. Forcing the grille out from one
corner alone will cause the grille to be deformed.
6
En
Make sure to press on the edges.
Pressing on the middle of the grille
will cause it to be deformed.
Connections
Connecting to an amplifier
Make sure you have read the connection instructions in
the manual supplied with the amplifier and that all
equipment is turned off before making any connections.
• When using a set of speakers connected to an
amplifier, you won't be able to obtain the correct
stereo effect if the polarity (+, –) of one of the
speakers (left or right) is reversed.
Additional Information
Cleaning the speaker
Use a dust brush to wipe off dust and dirt.
Never use furniture wax, cleaners, thinners, benzine,
insecticide sprays or other chemicals on or near the
speakers, since these will corrode the surfaces.