Pioneer S-L9-A-LRW 작동 지침 - 페이지 6

{카테고리_이름} Pioneer S-L9-A-LRW에 대한 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-L9-A-LRW 48 페이지. Stereo cd receiver; speaker system; stereo cassette deck
Pioneer S-L9-A-LRW에 대해서도 마찬가지입니다: 서비스 매뉴얼 (3 페이지), 서비스 매뉴얼 (3 페이지)

페이지 인쇄

1 Before You Start

Handling discs

When holding CDs of any type, take care not to leave finger-

prints, dirt or scratches on the disc surface. Hold the disc by its

edge or by the center hole and edge. Damaged or dirty discs can

affect playback and/or recording performance. Take care also

not to scratch the label side of the disc. Although not as fragile

as the recording side, scratches can still result in a disc

becoming unusable.

Should a disc become marked with fingerprints, dust, etc., clean

using a soft, dry cloth, wiping the disc lightly from the center to

the outside edge as shown in the diagram below. If necessary,

use a cloth soaked in alcohol, or a commercially available CD

cleaning kit to clean a disc more thoroughly. Never use benzine,

thinner or other cleaning agents, including products designed

for cleaning vinyl records.

Wipe lightly from the

center of the disc

using straight strokes

Storing discs

Although CDs are more durable than vinyl records, you should

still take care to handle and store discs correctly. When you're

not using a disc, return it to its case and store upright. Avoid

leaving discs in excessively cold, humid, or hot environments

(including under direct sunlight).

For more detailed care information see the instructions that

come with discs.

Discs to avoid

CDs spin at high speed inside the player during playback and

recording. If you can see that a disc is cracked, chipped, warped,

or otherwise damaged, don't risk using it in your CD player—

you could end up damaging the unit.

Don't wipe the disc

surface using circular

strokes

This unit is designed for use with conventional, fully circular

CDs only. Use of shaped CDs is not recommended for this

product. Pioneer disclaims all liability arising in connection

with the use of shaped CDs.

Using cassette tapes

The tape of a cassette is quite easily damaged and loose tape can

jam in the tape deck mechanism. If the tape has become

unwound, use a pen or pencil

to wind it back on to the spool.

When not using cassettes,

always store in the case. Store

cassettes away from magnetic

fields, excessive heat, humidity,

dust or oil.

Before recording on a tape,

wind the tape on past the leader tape (about the first 3 or 4

seconds of each side).

Avoid using tapes longer than 90 minutes.

Since tapes longer than 90 minutes are so thin, they are more

susceptible to jamming in the tape deck mechanism and other

trouble such as irregular winding.

Erase protection

You can protect an important recording against accidental

erasure by breaking the erase-protect tab(s) with a small

screwdriver.

For side B

If you want to re-record on an erase-protected cassette, cover the

space left by the broken tab with self-adhesive tape.

Note: If you're using Type II (High/C r O

you don't also cover the tape-type detection holes.

Tape-type detection hole

For side A

) tapes, make sure