Pioneer S-RS55TB 사용 설명서 - 페이지 2

{카테고리_이름} Pioneer S-RS55TB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-RS55TB 13 페이지.

페이지 인쇄

1. Operating Instructions

Surround Speakers

For best results the speakers should be positioned at or above ear

level. Depending upon your room layout and preferences, the left

and right rear speakers should be positioned on the side walls just

the rear of the listening position, or on the walls.

NON-SKID PADS

Use the supplied non-skip pads as necessary according to the

location chosen for installation. Stick the non-skid pads on the four

corners of the surface of the speaker on which it will be installed.

There will be locations, however, where there will be little benefit

from using the non-skid pads, so avoid putting in slippery places.

Put the units on a soft cloth when performing this task.

1. Front Speakers

2. Surround Speakers

3. Center Speaker

MAKING AMPLIFIER SETTINGS

Before connecting the speakers, please read the operating

instructions supplied with your amplifier to select the speaker

setting of amplifier:

• Front speakers: Large

• Center / surround speakers: Small

CONNECTING YOUR SYSTEM

• Make sure all equipment is turned off before making any

connections.

• You will not get the proper surround effects from the speakers if

you connect the poles (+ and –) incorrectly.

• These speaker terminals carry HAZARDOUS LIVE voltage.

To prevent the risk of electric shock when connecting or

disconnecting the speaker cables, disconnect the power cord

before touching any uninsulated parts.

Connect to the speaker terminals on the rear of the speakers

Connect the speaker cables to the speaker terminals on the rear of

the speakers. The poles of the input terminals are red for positive

(+) and black for negative (–). Match the colors of the speaker

terminals and speaker cables when connecting.

2 En

Front speakers:

After loosening the speaker terminals, push the wires into the

terminals, then tighten firmly.

Black 

Center and surround speakers:

While pushing the tabs of the speaker terminals, push the wires

into the terminals.

Black 

Connect to the speaker terminals on the rear of the amplifier

Connect the speaker cables to the speaker output terminals on the

rear of the amplifier. (For details, refer to the amplifier's instruction

manual.)

Amplifier

• After connecting the cord to the terminal, pull the cord gently

to make sure the end of the cord is firmly connected to the

terminal. Incomplete connection may result in the sound

jumping or noise being output.

• To prevent damage to the circuits, ensure that the + and – wires

of the speaker cables and the left and right wires do not touch

each other. Also take care that the bare wires do not touch the

rear panel of the amplifier.

Red 

Speakers