Pioneer S-RS88TB 운영 지침 - 페이지 2
{카테고리_이름} Pioneer S-RS88TB에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-RS88TB 4 페이지.
페이지 인쇄
CENTER SPEAKER
The speaker should be positioned below the TV. For best
results align the front of the speaker with the front of the
TV. If the speaker is placed under the TV and very close to
the floor, then tilting upwards may be beneficial.
Do not place the center speaker on top of TV, the speaker
may fall from the TV due to external shocks such as
earthquakes, endangering those nearby or damaging the
speaker.
SURROUND SPEAKERS
For best results the speakers should be positioned at or
above ear level. Depending upon your room layout and
preferences, the left and right rear speakers should be
positioned on the side walls just the rear of the listening
position, or on the walls.
STANDARD SURROUND SETUP
This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
Front
left
Surround left
NON-SKID PADS
If the front, center and surround speakers are placed on
a hard surface, such as wood or tile place four non-skid
pads on the bottom flat surface of the speakers.
Center speaker
Front speaker
2
En
Front
right
Center
Listening position
Surround right
Surround speakers
MAKING AMPLIFIER SETTINGS
Before connecting the speakers, please read the
operating instructions supplied with your amplifier to
select the speaker setting of amplifier :
• FRONT SPEAKERS : LARGE
• CENTER / SURROUND SPEAKERS : SMALL
CONNECTING YOUR SYSTEM
Make sure all equipment is turned off before making any
connections.
• Correct wiring of your speakers is essential for
achieving the best sound quality. Be careful to
ensure proper polarity of connection.
CAUTION
These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
Connect to the speaker terminals on the rear of
the amplifier.
Connect the striped speaker cord to the red (+) terminal
and the other cord to the black (–) terminal as shown
Subwoofer
below (for more details, refer to your amplifier instruction
manual).
Connect to the speaker terminals on the front of
the speakers.
Attach one end of the supplied speaker cord to the rear
of the each speaker. Connect the wire with the colored
marker to the red (+) terminal; the plain wire to the black
(–) terminal. Loosen the knobs on the input terminals and
insert the speaker cable wires into each of the terminal
post holes, then tighten the knobs.
Black
Amplifier
D3-4-2-2-3_A1_En
Speakers
Red
Red colored marker